2mm FLAT TOP LED LAMP WP13YD Features YELLOW Description MOUNTS FLUSH WITH PANEL. The Yellow source color devices are made with Gallium LOW POWER CONSUMPTION. Arsenide Phosphide on Gallium Phosphide Yellow Light SUITABLE FOR AUDIO PANEL INDICATOR. Emitting Diode. FITS 2mm HOLE IN PANEL UP TO 3.5mm (.138"). LONG LIFE - SOLID STATE RELIABILITY. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2531 REV NO: V.1 DATE: APR/18/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101001446 Selection Guide Part No. Dice WP13YD Iv (mcd) @ 10mA Lens Type YELLOW (GaAsP/GaP) Viewing Angle Min. Typ. 2 θ 1/2 3 8 70° YELLOW DIFFUSED Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2531 REV NO: V.1 DATE: APR/18/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101001446 Yellow WP13YD Remarks: If special sorting is required (e.g. binning based on forward voltage,luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2531 REV NO: V.1 DATE: APR/18/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101001446