3.2x1.6mm SMD CHIP LED LAMP P/N: KP-3216SEC SUPER BRIGHT ORANGE Description Features 3.2mmx1.6mm SMT LED, 1.1mm THICKNESS. The Super Bright Orange device is made with DH LOW POWER CONSUMPTION. InGaAlP (on GaAs substrate) light emitting diode chip. WIDE VIEWING ANGLE. IDEAL FOR BACKLIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAC1230 REV NO: V.6 DATE: NOV/11/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 1 OF 4 Selection Guide Part No. Dice KP-3216SEC Iv (mcd) @ 20mA Lens Type SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 70 200 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Orange λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Orange 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Orange Units Power dissipation 75 mW Forward Current 30 mA Peak Forward Current [1] 195 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAC1230 REV NO: V.6 DATE: NOV/11/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 2 OF 4 Super Bright Orange KP-3216SEC SPEC NO: DSAC1230 REV NO: V.6 DATE: NOV/11/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 3 OF 4 KP-3216SEC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAC1230 REV NO: V.6 DATE: NOV/11/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 4 OF 4