1.8mm SOLID STATE LAMP WP1060YD Features YELLOW Description 1.8mm DIAMETER SMALL SIZE LED LAMP. The Yellow source color devices are made with Gallium ULTRA BRIGHTNESS IS AVAILABLE. Arsenide Phosphide on Gallium Phosphide Yellow Light RELIABLE AND RUGGED. Emitting Diode. VERSATILE MOUNTING ON P.C. BOARD OR PANEL. AVAILABLE IN DIFFUSED LENS. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2118 REV NO: V.1 DATE: APR/11/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101002706 Selection Guide Part No. Dice WP1060YD Iv (mcd) @ 10mA Lens Type YELLOW (GaAsP/GaP) YELLOW DIFFUSED Viewing Angle Min. Typ. 2θ θ1/2 5 8 70° Note: 1.θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2118 REV NO: V.1 DATE: APR/11/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101002706 Yellow WP1060YD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2118 REV NO: V.1 DATE: APR/11/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: W.J.ZHU ERP:1101002706