T-1 (3mm) SOLID STATE LAMP WP7104YT YELLOW Features Description OPOPULAR T-1 DIAMETER PACKAGE. The Yellow source color devices are m ade OLOW POWER CONSUMPTION. OGENERAL PURPOSE LEADS. with Gallium Arsenide Phosphide on Gallium Phosphide Yellow Light Emitting Diode. ORELIABLE AND RUGGED. OLONG LIFE - SOLID STATE RELIABILITY. OAVAILABLE ON TAPE AND REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2365 REV NO: V.1 DATE: APR/18/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101008529 Selection Guide Part No. Dice WP7104YT Iv (mcd) @ 10mA Lens Type YELLOW (GaAsP/GaP) Viewing Angle Min. Typ. 2 θ 1/2 8 20 34° YELLOW TRANSPARENT Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA Reverse Voltage 5 V Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2365 REV NO: V.1 DATE: APR/18/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101008529 Yellow WP7104YT SPEC NO: DSAF2365 REV NO: V.1 DATE: APR/18/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101008529 PACKING & LABEL SPECIFICATIONS WP7104YT Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2365 REV NO: V.1 DATE: APR/18/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101008529