KINGBRIGHT WP13HD

2mm FLAT TOP LED LAMP
WP13HD
Features
BRIGHT RED
Description
MOUNTS FLUSH WITH PANEL.
The Bright Red source color devices are made with Gallium
LOW POWER CONSUMPTION.
Phosphide Red Light Emitting Diode.
SUITABLE FOR AUDIO PANEL INDICATOR.
FITS 2mm HOLE IN PANEL UP TO 3.5mm (.138").
LONG LIFE - SOLID STATE RELIABILITY.
RoHS COMPLIANT.
Package Dimensions
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.25(0.01") unless otherwise noted.
3. Lead spacing is measured where the leads emerge from the package.
4. Specifications are subject to change without notice.
SPEC NO: DSAF2529
REV NO: V.1
DATE: APR/18/2005
PAGE: 1 OF 3
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: W.J.ZHU
ERP:1101009210
Selection Guide
Part No.
Dice
WP13HD
Iv (mcd)
@ 10mA
Lens Type
BRIGHT RED (GaP)
RED DIFFUSED
Viewing
Angle
Min.
Typ.
2θ
θ1/2
0.4
1.5
70°
Note:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
λpeak
Peak Wavelength
Bright Red
λD
Dominant Wavelength
∆λ1/2
Typ.
Max.
Units
Test Conditions
700
nm
IF=20mA
Bright Red
660
nm
IF=20mA
Spectral Line Half-width
Bright Red
45
nm
IF=20mA
C
Capacitance
Bright Red
40
pF
VF=0V;f=1MHz
VF
Forward Voltage
Bright Red
2.25
2.5
V
IF=20mA
IR
Reverse Current
Bright Red
10
uA
VR = 5V
Absolute Maximum Ratings at TA=25°C
Parameter
Bright Red
Units
Power dissipation
120
mW
DC Forward Current
25
mA
Peak Forward Current [1]
130
mA
5
V
Reverse Voltage
Operating/Storage Temperature
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
SPEC NO: DSAF2529
REV NO: V.1
DATE: APR/18/2005
PAGE: 2 OF 3
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: W.J.ZHU
ERP:1101009210
Bright Red
WP13HD
Remarks:
If special sorting is required (e.g. binning based on forward voltage,luminous intensity, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous Intensity: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
SPEC NO: DSAF2529
REV NO: V.1
DATE: APR/18/2005
PAGE: 3 OF 3
APPROVED: J. Lu
CHECKED: Allen Liu
DRAWN: W.J.ZHU
ERP:1101009210