1.1x3.4mm RECTANGULAR SOLID LAMP WP1002HD Features BRIGHT RED Description LOW POWER CONSUMPTION. The Bright Red source color devices are made with Gallium RELIABLE AND RUGGED. Phosphide Red Light Emitting Diode. EXCELLENT UNIFORMITY OF LIGHT OUTPUT. SUITABLE FOR LEVEL INDICATOR. LONG LIFE-SOLID STATE RELIABILITY. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2556 REV NO: V.1 DATE: APR/16/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101009334 Selection Guide Part No. Dice WP1002HD Iv (mcd) @ 10mA Lens Type BRIGHT RED (GaP) RED DIFFUSED Viewing Angle Min. Typ. 2 θ 1/2 0.2 0.7 110° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Bright Red λD Dominant Wavelength ∆λ1/2 Typ. Units Test Conditions 700 nm IF=20mA Bright Red 660 nm IF=20mA Spectral Line Half-width Bright Red 45 nm IF=20mA C Capacitance Bright Red 40 VF Forward Voltage Bright Red 2.25 IR Reverse Current Bright Red Max. pF VF=0V;f=1MHz 2.5 V IF=20mA 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Bright Red Units Power dissipation 120 mW DC Forward Current 25 mA Peak Forward Current [1] 130 mA 5 V Reverse Voltage Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2556 REV NO: V.1 DATE: APR/16/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101009334 Bright Red WP1002HD Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2556 REV NO: V.1 DATE: APR/16/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101009334