4mm CYLINDRICAL LED LAMP WP1413SGDL Features SUPER BRIGHT GREEN Description CYLINDRICAL TYPE, FLAT TOP. The Super Bright Green source color devices are made CONVEX CATHODE MARK ON BODY. with Gallium Phosphide Green Light Emitting Diode. LOW POWER CONSUMPTION. I.C. COMPATIBLE. RELIABLE AND RUGGED. LONG LIFE - SOLID STATE RELIABILITY. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2542 REV NO: V.1 DATE:APR/16/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1101001464 Selection Guide Part No. Dice WP1413SGDL Iv (mcd) @ 20mA Lens Type SUPER BRIGHT GREEN (GaP) GREEN DIFFUSED Viewing Angle Min. Typ. 2 θ 1/2 2.6 10 100° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Green λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 565 nm IF=20mA Super Bright Green 568 nm IF=20mA Spectral Line Half-width Super Bright Green 30 nm IF=20mA C Capacitance Super Bright Green 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Green 2.2 2.5 V IF=20mA IR Reverse Current Super Bright Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2542 REV NO: V.1 DATE:APR/16/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1101001464 Super Bright Green WP1413SGDL Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2542 REV NO: V.1 DATE:APR/16/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1101001464