KWL-1020Ux SERIES Light Bar Display DESCRIPTION: PACKAGE DIMENSIONS + 8.40(0.33) 20.00(0.79) 18.60(0.73) 10.0(0.39) PIN 1 The KWL-1020Ux series is 10.16mm x 20.16mm rectangular type light bar display designed for a variety of applications where a large source of light is required, such as panel indicators, backlight legends and light arrays. o 6.15(0.24) ABSOLUTE MAXIMUM RATINGS: (Ta=25 C) INTERNAL CIRCUIT DIAGRAM TESTING CONDITION FOR EACH PARAMETER : Symbol Vf λρ ∆λ Ir Iv Unit V nm nm µA µ cd 7.62(0.3) 2.54*7=17.50(0.69) NOTES : 1. All dimensions are in millimeters (inches). 2. Tolerance is +0.25mm(0.010) unless otherwise specified. 3. Specifications are subject to change without notice. 4. NP: No Pin. 5. NC: No Connect. Parameter Forward Voltage Peak Emission Wave Length Spectral Line Half-Width Reverse Current Average Luminous Intensity _ 0.5 7.50 + φ0.50(0.02) Parameter Max Reverse Voltage per segment 5V Reverse Current per segment (Vr = 5V) 100µA Derating Linear from 25oC per segment 0.4mA/ oC Operating Temperature Range -40oC To 85oC Storage Temperature Range -40oC To 100oC Soldering Temperature 1.6mm(1/16") from body for 5 sec. at 260oC Test Condition If=20mA If=20mA If=20mA Vr=5V If=10mA 1 2 A E 16 15 3 4 B F 14 13 5 6 C G 12 11 7 8 D H 10 9 o PART NO. SELECTION AND APPLICATION INFORMATION (RATINGS AT 25 C AMBIENT) Chip Part No. Wave C.C or C.A Absolute Maximum Ratings Electro-optical Characteristic ∆λ Pd If 635 45 100 50 100 1.7 1.9 2.6 10-20 6.0 16.0 No 660 20 100 50 100 1.5 1.9 2.6 10-20 15.0 32.0 Green Common 565 30 100 50 100 1.7 2.2 2.6 10-20 6.0 14.0 GaP Super Green Polar 570 30 100 50 100 1.7 2.2 2.6 10-20 8.5 20.0 GaAsP/GaP Yellow 585 30 100 50 100 1.7 1.9 2.6 10-20 6.0 14.0 Raw Material Emitted Color KWL-1020U3 GaAsP/GaP Hi-Eff. Red KWL-1020US GaAlAs Super Red KWL-1020U2 GaP KWL-1020UG KWL-1020U6 Length λρ (nm) If If Vf (V) Iv (mcd) (Peak) (Rec) Per Chip (nm) (mW) (mA) (mA) Min. Typ. Max. mA Min. Typ. REMARKS : 1. The average luminous intensity is obtained by summing the luminous intensity of each segment and dividing by the total number of segments. 2. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE (International Commission on Illumination) eye-response curve. 3. Clean only by pure water, isopropanol, ethanol, Freon TF (or equivalent).