Clock Oscillators Surface Mount Type KC7050B Series (FXO-37FNB) CMOS/ 5.0V/ 7.0×5.0mm Features • Surface mount type suitable for auto pick-and-place • Reflow compatible • CMOS, TTL IC direct drive is possible • With tri-state function • Broad frequency range 80MHz (PLL circuit is built in) • Supply voltage VCC=5.0V available Frequency Tolerance (Overall) Freq. Tol. Code × 10-6 RoHS Compliant ±50 Z “Designated for MFP3N, Communication LSI for CC-Link Remote Device” Operating Temperature Range (°C) Note -10 to +85 80MHz How to Order KC7050B 80.0000 C 5 Z B QZ ① ② ③④⑤⑥ ⑦ ① Type ② Output Frequency ③ Output Type (CMOS) ④ Supply Voltage 5=5.0V ⑤ Frequency Tolerance (See Table at Left) ⑥S ymmetry/ INH Function (40/ 60%, Stand-by) ⑦C ustomer Special Model Suffix (STD Specification is “QZ”) Specifications Item Symbol Output Frequency Range Frequency Tolerance (Overall) Storage Temperature Range Operating Temperature Range Max. Supply Voltage Supply Voltage Current Consumption Stand-by Current Symmetry Rise/ Fall Time Low Level Output Voltage High Level Output Voltage CMOS Load Input Voltage Range Low Level Input Voltage High Level Input Voltage Disable Time Enable Time Start-up Time Specifications Min. Max. 80 -50 +50 -20 +85 -10 +85 +6 — +4.75 +5.25 — 50 — 40 40 60 — 5 — 10% VCC 90% VCC — — 15 VSS VCC — 0.8 2.2 — — 100 — 100 — 10 Conditions fo f_tol T_stg T_use — VCC 5.0V Typ. ICC I_std SYM @50% VCC tr/ tf VOL VOH @5.0 V L_CMOS VIN VIL VIH t_dis t_ena t_str Units MHz ×10-6 °C °C V V mA μA % ns V V pF V V V ns μs ms Note: All electrical characteristics are defined at the maximum load and operating temperature range. Please contact us for inquiry about operating temperature range, available frequencies and other conditions. Dimensions (Unit: mm) #4 #2 #1 1.8 5.1 0.6 5.1 Plating: Ni+Au Tolerance: ±0.2 Pad Connections #1 INH #2 GND #3 Output #4 VCC INH Function Pad1 Pad3 (Output) Open Active "H" Level Active "L" Level High Z (No-Oscillation) 2.0 1.4 #3 (Unit: mm) 4.2 4.6 5.0 0.6 2.6 7.0 Recommended Land Pattern 1.8 Note: A capacitor of value 0.01µF between VCC and GND is recommended.