NES-15 15W Single Output Switching Power Supply series Features : Universal AC input/Full range Protections: Short circuit / Overload / Over voltage / Over temperature Cooling by free air convection 100% full load burn-in test 2 years warranty SPECIFICATION MODEL OUTPUT NES-15-5 NES-15-12 NES-15-15 NES-15-24 DC VOLTAGE 5V 12V 15V 24V 48V RATED CURRENT 3A 1.3A 1A 0.7A 0.35A CURRENT RANGE 0 ~ 3A 0 ~ 1.3A 0 ~ 1A 0 ~ 0.7A 0 ~ 0.35A RATED POWER 15W 15.6W 15W 16.8W 16.8W RIPPLE & NOISE (max.) Note.2 150mVp-p 150mVp-p 150mVp-p 200mVp-p 240mVp-p VOLTAGE ADJ. RANGE 10.8 ~ 13.2V 1.0% 13.5 ~ 16.5V 1.0% 21.6 ~ 26.4V 1.0% 43.2 ~ 52.8V 1.0% VOLTAGE TOLERANCE Note.3 INPUT 4.75 ~ 5.5V 2.0% LINE REGULATION Note.4 1.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION Note.5 1.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE TIME 1000ms, 30ms/230VAC HOLD UP TIME (Typ.) 100ms/230VAC VOLTAGE RANGE 85 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY (Typ.) 79% 0.35A/115VAC AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 20ms/115VAC at full load 120 ~ 370VDC 81% 0.25A/230VAC 81% 85% COLD START 45A <2mA / 240VAC OVERLOAD Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16.2V Protection type : Shut off U1 Tj 140 OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 6) HARMONIC CURRENT EMS IMMUNITY MTBF DIMENSION PACKING NOTE 1000ms, 30ms/115VAC at full load LEAKAGE CURRENT PROTECTION OVER VOLTAGE OTHERS NES-15-48 17.25 ~ 20.25V 27.6 ~ 32.4V 82% 55.2 ~ 64.8V typically (U1) detect on main control IC Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +60 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -40 ~ +85 , 10 ~ 95% RH 0.03%/ (0 ~ 45 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes UL60950-1, CB(IEC60950-1),CCC GB4943 approved I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 Compliance to EN55022 (CISPR22) Class B / 70% RH Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2, 3, 4, 5, 6, 8,11, ENV50204, EN55024, EN61000-6-1, light industry level, criteria A 563.5Khrs min. MIL-HDBK-217F (25 78*51*28mm (L*W*H) 0.18Kg; 60pcs/11.8Kg/0.46CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Line regulation is measured from low line to high line at rated load. 5. Load regulation is measured from 0% to 100% rated load. 6. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to EMI testing of component power supplies. (as available on http://www.meanwell.com) File Name:NES-15-SPEC 2010-10-18 NES-15 15W Single Output Switching Power Supply Mechanical Specification Case No. 931A series Unit:mm 7.62 1 2 51 3 2-M3 L=4 25.4 6 4 5 LED +V ADJ. 10.5 55 78 14 max. Assignment AC/L AC/N FG Pin No. 4 5 Assignment DC OUTPUT -V DC OUTPUT +V 2-M3 14 Pin No. 1 2 3 28 Terminal Pin No. Assignment 2.75 66.5 Block Diagram fosc : 67KHz RECTIFIERS & FILTER EMI FILTER I/P RECTIFIERS & FILTER POWER SWITCHING PWM CONTROL FG Derating Curve +V -V DETECTION CIRCUIT Output Derating VS Input Voltage Ta=25 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -20 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 85 95 100 115 120 140 160 180 200 220 240 264 INPUT VOLTAGE (VAC) 60Hz File Name:NES-15-SPEC 2010-10-18