MOTOR START HARDWARE MSC SERIES CAPACITOR HARDWARE End Cap for On−Motor Mounting Part Number Diameter (inches) Fits Case Style MSCH−01 1.438 E, F, G MSCH−02 1.810 H, J MSCH−03 2.060 K MSCH−04 2.560 L End Cap for Off−Motor Mounting Part Number Diameter (inches) Fits Case Style MSCH−05 1.438 E, F, G MSCH−06 1.810 H, J MSCH−07 2.060 K MSCH−08 2.560 L Mounting Bracket Part Number Fits Case Style MSCH−09 E, F MSCH−10 H MSCH−11 G, J, K, L END CAP MOUNTING When assembling directly to the motor frame, the wires are brought through the bracket hole and attached to the capacitor terminals. Types MSCH−01, 02, 03, and 04 end caps are then placed in position and the entire assembly snapped into place. Off−motor mounting is similarly accomplished except the MSCH−05, 06, 07, and 08 end caps should be used to provide for leads emerging from the opposite side of the cap without going through the bracket hole. Use NTE p/n 2W315, a 15k 2Watt bleeder resistor, for AC motor start applications to save the relay switch contacts and capacitor, particularly in capacitor start−run applications. NTE Electronics, Inc. Voice (973) 748−5089 FAX (973) 748−6224 http://www.nteinc.com 59