RFHIC RTP09050-10

RTP09050-10
GaN Power Amp Pallet
Product Features
Application
• Doherty amplifier design
• Small and light weight
• 50 Ohm Input/Output impedance matched
• Highly reliable and rugged design
• High efficiency, High Gain
• 52.5W typical PAVG
• LTE, GSM RRH
Description
This HPA Module is a high gain and Amplifier module for GSM and LTE Repeater use.
Electrical Specifications @ VDD= 31V, 50Ω System
PARAMETER
Symbol
Specification
Frequency Range
BW
925 ~ 960MHz
Operating Bandwidth within BW
OBW
5 ~ 35MHz
Average Output Power
Pout
47.2dBm(52.5W) Avg. @ LTE 1FA 10MHz
Peak Output Power
Psat
54.8dBm (Min.) @ Duty 10% Pulse
ACLR (LTE 1FA 10MHZ)
@ Po=+47.2dBm max.
GSM Multi Carrier IMD
(PAPR 7.5dB)
Pre-DPD
-27dBc(Min)
@±10MHz
Post-DPD
-53dBc(Min)
@±10MHz
Pre-DPD
-25dBc(Min)
@±15MHz
Post-DPD
-55dBc(Min)
@±15MHz
ACLR
IMD
@-30 ~ +60°C
@31V
@CFR 7.5dB
@-30 ~ +60°C
@31V
@CFR 7.5dB
G
57dB (Min.)
Gain Flatness
ΔG
2.0 dB(Peak to peak) @ Operating Frequency
Input Return Loss
S11
-12dB (Max.)
Output Return Loss
S22
-17dB (Max.)
Normal Operating Voltage
VDC
+5.6V, +31V
Current Consumption
IDD
0.3A @ 5.6V (Max.)
4.2A / 31V (Typ.)
Efficiency
Eff
40% @ 31V (Typ.)
Feedback Output level @ 47.2dBm
FB
+8dBm ± 1.5dB
RF Gain @ 25℃
Temp Detector
T
0.9V @ 40℃
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
RTP09050-10
GaN Power Amp Pallet
Environmental Characteristics
Parameter
Symbol
Min.
Ta
Storage Temperature
Tstg
Relative humidity w/o condensation
RH
Operating Ambient Temperature
Typ.
Max.
Unit
-30
+65
°C
-40
+130
°C
80
%
Maximum Rating
POD
-2dBm
Max.
Load VSWR
Ψ
∞ : 1 (All Phase & Amplitude)
Nom.
Operating Case Temperature
Tc
+100
°C
Input Overdrive
Interface Connector
8-Pin-Control (MOLEX_5267_08)
Pin #
Description
Specifications
1
Vcc
+5.6V
2
Vcc
+31V
3
Vcc
+31V
4
Vcc
+31V
5
GND
GROUND
6
GND
GROUND
7
GND
GROUND
8
GND
GROUND
Yeonho 4Pin-Control (SMW200-04P)
Pin #
Description
Specifications
1
Enable
Amp Enable(+5.6V) / Amp Disable(+0V)
2
GND
GROUND
3
GND
GROUND
4
Temp DET
Temp Sense (0.9V @ 40℃)
Mechanical Specifications
Parameter
Dimensions
Weight
Value
Units
185 ⅹ 125 ⅹ 18.8
mm
0.75(max)
Kg
Limits
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
RTP09050-10
GaN Power Amp Pallet
RF Input Connector
SMA(Female)
RF Output Coupling Connector
SMA(Female)
RF Output Connector
SMA(Female)
SMW200 4pin(Male)
I/O Connector
Molex 8pin(Male)
Cooling
External Heat-sink
Outline Drawing
COVER (T=11.7)
GASKET (T=0.3)
PCB (T=0.8)
FLANGE (T=6.0)
4
I/O
1 Enable
2 GND
3 GND
4 Temp DET
1
1
INPUT
I/O
8
1
2
3
4
5
6
7
8
+5.6V
+31V
+31V
+31V
GND
GND
GND
GND
FB
CAUTION
WHEN THE CASE IS OPEN
THIS DEVICE IS SUSCEPTIBLE
TO DAMAGE FROM E.S.D OR E.M.I
OUTPUT
(0,0)
*Note : Connector positions and module mount holes may be subjected change.
Unit : mm
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
GaN Power Amp Pallet
RTP09050-10
RTP09050-10 Budget
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
GaN Power Amp Pallet
RTP09050-10
Test Data (Test Results: DPD Operation)
Test Equipments
-
DPD Engine : Optichron OP6180 Board
-
Signal Generator : E4438C (Agilent)
-
Spectrum Analyzer : E4440A (Agilent)
-
Network Analyzer : 8753ES (Agilent)
-
Power Supply : 6674A (Agilent)
Test Condition
-
Signal : LTE 1FA 10MHz(PAPR 7.5dB) & GSM 4FA(PAPR 7.5dB)
-
CFR apply
-
AMP Temperature: 40°C
●
●
Gain (S21)
●
Input VSWR (S11)
Output VSWR (S22)
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
GaN Power Amp Pallet
Pre – DPD @ 930MHz
● Post-
DPD @ 930MHz
Pre – DPD @ 942.5MHz
● Post-
DPD @ 942.5MHz
●
●
RTP09050-10
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
GaN Power Amp Pallet
●
Pre – DPD @ 955MHz
Pulse Duty 10% @ 930MHz
RTP09050-10
● Post-
DPD @ 955MHz
Pulse Duty 10% @ 942.5MHz
Pulse Duty 10% @ 955MHz
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0
RTP09050-10
GaN Power Amp Pallet
GSM 4FA Tone Spacing 15MHz (Fc = 942.5MHz ,PAPR 7.5dB)
GSM 4FA Tone Spacing 15MHz (Fc = 942.5MHz,PAPR 7.5dB)
Test Sheet
S/N
0001
Gain
58.4 dB
Gain Flatness
1.7 dB
S11(Min)
-19.4 dB
S22(Min)
-19.5 dB
Feedback level@ 47.2dBm
6.4dBm
Test Frequency (@Center)
930 MHz
942.5 MHz
955 MHz
Psat (dBm)
55.2
55.4
55.2
Pre-DPD
-29.8
-29.2
-27.5
Post-DPD
-56.9
-56.4
-55.3
300mA/5.6V, Current/31V
A
3.81
3.8
3.93
Efficiency
%
44.4
44.5
43.1
LTE
ACLR@±10MHz
10MHz
(dBc)
@50W
GSM 4FA @
Worst
Tone Spacing
Spurious
15MHz (PAPR 7.5dB)
(dBc)
Pre-DPD
-30.9
Post-DPD
-59.0
RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not
assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or
incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for
inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not
intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells
such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders,
employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of
whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC.
▪ Tel : 82-31-250-5075
▪ All specifications may change without notice.
▪ [email protected]
▪ Version 1.0