XTL1006 • Surface Mount Seam-Weld Package • Good Frequency Stability over Temperature • Excellent Reliability • Complies with Directive 2002/95/EC (RoHS) 13.56000 MHz Crystal Unit 2 > The XTL1006 is a surface mount 5.0 x 3.2 mm crystal unit for use in wireless telecommunications devices, especially where an ultra-miniature package is needed for mobility. SM5032-4 Case Electrical Characteristics Characteristic Sym Notes Minimum Typical Nominal Frequency 13.56000 Mode of Oscillation Fundamental Storage Temperature Range Maximum MHz TBD Operating Temperature Range -40 Frequency Stability over Operating Temperature Range Equivalent Series Resistance °C +125 °C ±50 ppm (referred to the value at 25 °C FL Frequency Make Tolerance Units ±50 ppm @ 25°C ±3 °C ESR 50 Nominal Drive Level Shunt Capacitance CO Load Capacitance CL Stanard Shipping Quantity on 330 mm (13”) Reel Lid Symbolization (in addition to Lot and/or Date Codes) Ω 10 uW 2.0 pF 3 pF 3000 units 1006 YWWS C r y s ta l E q u iv a le n t C ir c u it 2 C E S R 4 O CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. The design, manufacturing process, and specifications of this device are subject to change without notice. www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 1 of 3 XTL1006 - 2/3/10 SM5032-4 Case 4-Terminal Surface-Mount Seam Weld Case 5.0 x 3.2 mm Nominal Footprint 3.2 ±0.1 5.0 ±0.1 Top View Connection 1 GND 2 IN/OUT 3 GND 4 IN/OUT Side View Note: Pin #1 & #3 are connected to metal cap on top 0.8 ±0.1 Pin 0.8 ±0.1 Electrical Connections 1.2 ±0.1 1.2 ±0.1 2.4 ±0.2 pin 2 pin 3 pin 1 pin 4 1.4 ±0.2 1.2 ±0.1 1.7 ±0.1 Bottom View Package Dimensions (mm) 2.2 ±0.1 Dot Indicates Pin 1 Footprint (mm) 1006 YWWS 1006 YWWS 1006 YWWS Package Orientation in Carrier Tape www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 2 of 3 XTL1006 - 2/3/10 Reel Dimensions Tape Dimensions Notes: 1. Unless otherwise specified, tolerance on dimensions is ±0.1 mm 2. Material is black conductive polystyrene 3. 10 pitch cumulative tolerance is ±0.2 mm www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 3 of 3 XTL1006 - 2/3/10