601 MHz SAW Filter 26 MHz Bandwidth Part Number SF0601BA03160S DESCRIPTION • • • 601 MHz SAW bandpass filter with 26 MHz bandwidth. 3.8 x 3.8 mm LCC package. RoHS compliant. TYPICAL PERFORMANCE Horizontal: Vertical: Frequency - Center : Span : Magnitude : Magnitude : Group Delay : 600 300 10 1 20 MHz MHz dB/div dB/div ns/div IDT • SAW Products • 324 Clark Street, Worcester, MA 01606, USA • Ph 1-508-852-5400 • Fax 1-508-852-8456 www.idt.com DSSF0601BA03160S Rev 02-Dec-2007 ECN 35690 Page 1 of 3 601 MHz SAW Filter 26 MHz Bandwidth Part Number SF0601BA03160S SPECIFICATION Parameter Nominal Center Frequency FC Passband Maximum Insertion Loss over the Passband Absolute Delay Rejection (0.3 to 506 MHz) 1 Rejection (506 to 526 MHz) 1 Rejection (526 to 575 MHz) 1 Rejection (627 to 676 MHz) 1 Rejection (676 to 696 MHz) 1 Rejection (696 to 901 MHz) 1 Rejection (901 to 1056 MHz) 1 Amplitude Variation over the Passband Group Delay Ripple in Passband Source/Load Impedance Temperature Coefficient of Frequency, Tc 2 Ambient Temperature (Tref) Notes: Min 588 40 38 10 10 20 40 40 - Typ 601 4.25 40 47 39 14 11 22 42 43 0.9 10 50 -70 23 - Max 614 4.5 1.5 100 Units MHz MHz dB ns dB dB dB dB dB dB dB dB p-p ns p-p ohms ppm/˚C ˚C - 1. Absolute level 2. Typical shift of filter frequency response with temperature is ∆f = (T-Tref)*Tc*Fc. MAXIMUM RATINGS Parameter Storage Temperature Range Operating Temperature Range Input Power Level Min Max -45 -20 - 85 55 10 Units ˚C ˚C dBm MATCHING CIRCUIT Notes • • 50 ohm single ended operation. Matching components are not required. IDT • SAW Products • 324 Clark Street, Worcester, MA 01606, USA • Ph 1-508-852-5400 • Fax 1-508-852-8456 www.idt.com DSSF0601BA03160S Rev 02-Dec-2007 ECN 35690 Page 2 of 3 601 MHz SAW Filter 26 MHz Bandwidth Part Number SF0601BA03160S PACKAGE OUTLINE SUGGESTED FOOTPRINT Units: mm Tolerances are ±0.15 mm except where indicated. Pad Configuration: Input: 2 Output: 5 Ground: 1, 3, 4, 6 Package Material: Body: Al2O3 ceramic Lid: Kovar, Ni plated Terminations: Au plating 1 µm min, over a 1.3-8.9 µm Ni plating ISO 9001 Registered All specifications are believed to be accurate and reliable. However, MNC reserves the right to make changes without notice. © 2007 All rights reserved. IDT • SAW Products • 324 Clark Street, Worcester, MA 01606, USA • Ph 1-508-852-5400 • Fax 1-508-852-8456 www.idt.com DSSF0601BA03160S Rev 02-Dec-2007 ECN 35690 Page 3 of 3