SYNC-POWER SP3406S25RGB

SP3406
600mA Buck Converter
DESCRIPTION
APPLICATIONS
SP3406 is a high efficiency monolithic
synchronous buck regulator using a constant
frequency, current mode architecture. The device
is available in an adjustable version and fixed
output voltages, such as 1.5V,1.8V,etc. Supply
current with no load is 30uA and drops to <1uA in
shutdown. The 2.5 to 6.5V input voltage range
makes the SP3406 ideally suitable for single
Li-Ion, two to four AA battery-powered
applications. In low dropout operation mode, the
duty cycle can reach to 100%, extending battery
life in portable systems. PWM pulse skipping mode
operation provides very low output ripple voltage
for noise sensitive applications. Switching
frequency is internally set at 1.5MHz, allowing the
use of small surface mount inductors and
capacitors. The internal synchronous switch
increases efficiency and eliminates the need for an
external Schottky diode. Low output voltages are
easily supported with the 0.6V feedback reference
voltage. The SP 3406 is available in a small
SOT-23-5 package.
Digital Camera
PDA
Hand Held Communication Equipment
Wireless and DSL Modems
Portable instrument
Microprocessor and DSP Core Supplies
MID or UPMC
FEATURES
PIN CONFIGURATION ( SOT-23-5L)
High Efficiency: Up to 96%;
1.5MHz Constant Switching Frequency;
600mA Output Current at Vin=3V;
Integrated Main Switch and Synchronous
Rectifier, No Schottky Diode Required;
2.5 to 6.5V input voltage;
Output Voltage as Low as 0.6V;
100% Duty Cycle in Dropout;
Quiescent Current: 30uA(input<4.2V);
Slope Compensated Current Mode Control for
Excellent Line and Load Transient Response;
Short Circuit Protection and Thermal Fault
Protection;
<1uA Shutdown Current;
Soft Start;
2012/11/15
V. 1
PART MARKING
Page 1
SP3406
600mA Buck Converter
TYPICAL APPLICATION CIRCUIT
Vout = 0.6 × (1+
R2
)
R1
PIN DESCRIPTION & ELECTRICAL CHARACTERISTICS
Pin
Symbol
Description
Min.
Operating Rating
Typ.
Max.
Unit
1
2
3
RUN
GND
SW
Control Input
Ground
Switch Node Connect to Inductor
-0.3
-0.3
-0.3
VIN
VIN+0.3
VIN+0.3
V
V
V
4
5
VIN
VFB
Supply Voltage
Feedback
-0.3
-0.3
6.5
VIN
V
V
BLOCK DIAGRAM
ORDERING INFORMATION
Part Number
Package
SP3406S25RGB
SOT-23-5L
※ SP3406S25RGB : 7” Tape Reel; Pb – Free, Halogen-Free
2012/11/15
V. 1
Part Marking
3406
Page 2
SP3406
600mA Buck Converter
ABSOULTE MAXIMUM RATINGS (TA=25℃, unless otherwise specified.)
The following ratings designate persistent limits beyond which damage to the device may occur.
Symbol
VIN
IOUT
TJ
TSTG
TLEAD
Tope
RӨJC
Parameter
Value
-0.3 ~ 6.5
1.3
125
-65 to 150
260
-40 ~ 85
250
DC Supply Voltage
SW Current, Source or Sink
Operating Junction Temperature Range
Storage Temperature Range
Lead Soldering Temperature for 5 sec.
Operation Temperature Range
Thermal Resistance Junction – Case (*)
Unit
V
A
℃
℃
℃
℃
℃/W
ELECTRICAL CHARACTERISTICS
(Unless otherwise stated, these specifications apply TA=25°C; V IN=3.6V)
Symbol
SUPPLY
VIN
IIN
Parameter
Supply Voltage
Input DC Bias Current
Active mode
Input DC Bias Current
Sleep Mode
Input DC Bias Current
Shutdown Mode
RUN Threshold
RUN Leakage Current
VRUN
IRUN
FEEDBACK
VFB
Regulated Feedback Voltage
Reference Voltage Line
ΔVFB
Regulation
IFB
Feedback Current
Output Voltage Load
VLOADREG
Regulation
IPEAK
Peak Induct Current
SWITCHING REGULATOR
RPMOS *
RDS(on) for P MOSFET
RNMOS *
RDS(on) for N MOSFET
ILSW
SW Leakage Current
fOSC
Oscillator Frequency
Conditions
Min.
Typ.
Max.
Unit
6.5
V
300
400
uA
20
35
uA
0.1
1
uA
0.3
1
0.01
1.5
1
V
uA
0.588
0.6
0.612
V
0.04
0.4
%/V
30
nA
2.5
VFB = 0.5V or VOUT =
90%, ILOAD = 0A
VFB = 0.62V or VOUT =
103%, ILOAD = 0A
VRUN <0V, VIN = 4.2V
VIN = 2.5V to 5.5V
0.5
VIN = 3V, VFB = 0.5V, Duty
Cycle < 35%
ISW = 100mA
ISW = 100mA
VRUN = 0V, VIN = 5V, VSW
= 0V or 5V
VFB = 0V or VOUT = 0V
VFB=0.6V or VOUT=100%
0.75
1.2
%
1
1.25
A
400
350
500
450
mΩ
mΩ
0.01
1
uA
1.5
1.8
MHz
* Guaranteed by Design
2012/11/15
V. 1
Page 3
SP3406
600mA Buck Converter
TYPICAL PERFORMANCE CHARACTERISTICS
TA= +25℃; unless otherwise noted.
Output Voltage vs. Load Current
Oscillator Frequency vs. Supply Voltage
Efficiency vs. Output Current
Output Voltage vs. Input Voltage
Normal Operating Waveforms
VIN=4.2V,VOUT=2.5V,IOUT=0.6A
Short Circuit Protection Waveforms
VIN=4.2V,VOUT=2.5V,IOUT=0.6A
CH1:
:VSW
2012/11/15
V. 1
, CH2:
: IL
, CH3:
:Vout
Page 4
SP3406
600mA Buck Converter
SOT 23-5L PACKAGE OUTLINE
2012/11/15
V. 1
Page 5
SP3406
600mA Buck Converter
Information provided is alleged to be exact and consistent. SYNC Power Corporation presumes no responsibility
for the penalties of use of such information or for any violation of patents or other rights of third parties, which may
result from its use. No license is granted by allegation or otherwise under any patent or patent rights of SYNC
Power Corporation. Conditions mentioned in this publication are subject to change without notice. This
publication surpasses and replaces all information previously supplied. SYNC Power Corporation products are
not authorized for use as critical components in life support devices or systems without express written approval of
SYNC Power Corporation.
©The SYNC Power logo is a registered trademark of SYNC Power Corporation
©2012 SYNC Power Corporation – Printed in Taiwan – All Rights Reserved
SYNC Power Corporation
7F-2, No.3-1, Park Street
NanKang District (NKSP), Taipei, Taiwan, 115, R.O.C
Phone: 886-2-2655-8178
Fax: 886-2-2655-8468
http://www.syncpower.com
2012/11/15
V. 1
Page 6