1 Pt100 KN 1515 The KN Series Ceramic Wire Wound PRTDs are suitable for general applications requiring temperature stability. Applications: Industrial resistance thermometers, especially in chemical, power generation plants and analytical equipment. Construction: A platinum coil is sealed inside a high purity aluminum oxide ceramic body. Lead wires are shear force resistant and assure proper connection to extension leads and cables. Models Description Tolerance IEC 60751 Order No. 1Pt100 KN 1515 W0.3 W0.15 W0.1 W0.03 32.206.455 32.206.456 32.206.457 32.206.112 1Pt100 KN 1515 G W0.3 W0.15 W0.1 32.206.901 32.206.902 32.206.903 Response time Self Heating 0°C (K/mW) Water current Air stream V=3m/s V=0.4m/s Dimensions mm L D d l +2 15- 0 1.5±0.15 0.20±0.01 10.0±0.5 +2 15- 0 1.5±0.15 0.27±0.01 10.0±0.5 t 0.5 t 0.9 t 0.5 t 0.9 0.08 0.2 0.4 5.0 15.7 0.08 0.2 0.4 5.0 15.7 Technical Specification 100 Ohm @ 0 °C Temperature range: W0.3 (Class B) = -196 to +660 °C W0.15 (Class A) = -196 to +600 °C (Heraeus exceeds IEC 60751: -100 to +450 °C) Insulation resistance > 100 MOhm @ 25 °C after assembly: Measuring current: Tolerance class: W0.1 (Class 1/3 B) = -100 to +350 °C W0.03 (Class 1/10 B) = -50 to +300 ºC (Special HST Class proportional to W0.3) Temperature coefficient: Tc = 3850 ppm/K Leads: Palladium-gold alloy The measuring point is located at 8 mm from the end of the sensor body 1 mA - According to IEC 60751:2008 - Other standards and narrower tolerances are available on request Temperature stability: Excellent long-term stability Also available: - Platinum-gold alloy - Different temperature coefficients (3916 ppm/K - old JIS) - Extension leads - Two separated coils can be embedded in one ceramic body Heraeus Sensor Technology USA 1901 Route 130 North Brunswick, NJ 08902 Phone 732-940-4400 Fax 732-940-4445 Email [email protected] www.hst-us.com Status: HSTUSA 11/09 Status 01/2009. Technical modifications reserved. Nominal resistance: