Flat Washers Features: • • • DIN 125 A Form A steel washers Standard washer for protection of mating material and spreading the clamp load Bright zinc plated Specification Table Description Thread External Diameter Internal Diameter Part Number Washer, Form A, BZP, M2 M2 5 2.2 D01098 M2.5 - - D01099 Washer, Form A, BZP, M3 M3 7 3.5 D01100 Washer, Form A,BZP, M3.5 M3.5 - - D01101 Washer, Form A, BZP, M4 M4 9 4.3 D01102 Washer, Form A, BZP, M5 M5 10 5.3 D01103 Washer, Form A, BZP, M6 M6 - - D01104 Washer, Form A, BZP, M8 M8 16 8.2 D01105 Washer, Form A, BZP, M10 M10 20 10.5 D01106 Washer, Form A, BZP, M2.5 Dimensions : Millimetres Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. DURATOOL is the registered trademark of the Group. © Premier Farnell plc 2011. www.element14.com www.farnell.com www.newark.com www.cpc.co.uk www.mcmelectronics.com Page <1> 20/09/11 V1.1