RUILON 15KPA58A

ELECTRONICS
Transient
Voltage
Suppressors
15KPA Series
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Transient Voltage Suppressors - 15KPA Series
Features
UNI
1. Halogen-free
2. Rohs compliant
3. Typical maximum temperature coefficient
4. ΔVBR =0.1%xVBR@25°C x ΔT
BI
5. Glass passivated Chip junction in P600 package
6. 5000W peak pulse capadility at 10x1000μs waveform,repetition rate (duty
cycles):0.01%
7. Fast response time:typically less than 1.0ps from 0 Volts to BV min
8. Excellent clamping capability
9. Low incremental surge resistance
10. Typical IR less than 5μA above 12V
BI
Cathode
11. High temperature soldering guaranteed: 260°C/40 seconds / 0.375”,
Anode
\(9.5mm) lead length, 5lbs., (2.3kg)tension
12. Plastic package has underwriters laboratory flammability classification
UNI
94v-0
Applications
TVS devices are ideal for the protection of I/O interfaces,VCC bus and other vulnerable circuits used in telecom, computer,
industrial and consumer electronic applications.
Mechanical Characteristics
Rating
Symbol
Value
Units
PPPM
15000
Watts
PD
8
Watts
IFSM
400
Amps
VF
3.5/5.0
V
Operating junction and Storage Temperature Range.
TJ,TSTG
-55°C to 175°C
°C
Typical Thermal Resistance Junction to Lead
RuJL
8.0
°C/W
Typical Thermal Resistance Junction
to Ambient
RuJA
40
°C/W
Peak Pulse Power Dissipation by 10x1000μs test waveform
(Fig.1)(Note 1)
Steady State Power Dissipation on
inifinite heat sink at TL=75°C (Fig. 5)
Peak Forward Surge Current, 8.3ms Single Half Sine Wave
Unidirectional only (Note 2)
Maximum Instantaneous Forward Voltage at 25A for
Unidirectional only (Note 3)
Notes:
1. Non-repetitive current pulse , per Fig. 3 and derated above TA = 25°C per Fig. 2.
2. Measured on 8.3ms single half sine wave or equivalent square wave, duty cycle=4 perminute maximum.
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:1
Transient Voltage Suppressors - 15KPA Series
Electriacl Characteristics
Reverse StandOff Voltage
Type Number
(UNI)
(BI)
15KPA17A
15KPA17CA
VRWM(V)
17.0
15KPA18A
15KPA18CA
15KPA20A
Breakdown
Voltage
@IT
VBR MIN.(V)
Test
Current
18.99
IT(mA)
50
18.0
20.11
15KPA20CA
20.0
15KPA22A
15KPA22CA
15KPA24A
Maximum
Clamping Voltage
@IPP
VC(V)
Peak Pulse
Current
Reverse
Leakage
@VRWM
IR(µA)
29.3
IPP(A)
515.4
50
30.9
488.7
5000
22.34
20
34.3
440.2
1500
22.0
24.57
10
37.1
407.0
500
15KPA24CA
24.0
26.81
5
40.7
371.0
150
15KPA26A
15KPA26CA
26.0
29.04
5
44.0
343.2
50
15KPA28A
15KPA28CA
28.0
31.28
5
47.5
317.9
25
15KPA30A
15KPA30CA
30.0
33.51
5
50.7
297.8
15
15KPA33A
15KPA33CA
33.0
36.90
5
54.7
276.1
5
15KPA36A
15KPA36CA
36.0
40.20
5
59.8
252.5
5
15KPA40A
15KPA40CA
40.0
44.70
5
65.8
229.5
5
15KPA43A
15KPA43CA
43.0
48.00
5
69.8
216.3
5
15KPA45A
15KPA45CA
45.0
50.30
5
72.8
207.4
5
15KPA48A
15KPA48CA
48.0
53.60
5
77.7
194.3
5
15KPA51A
15KPA51CA
51.0
57.00
5
82.9
182.1
5
15KPA54A
15KPA54CA
54.0
60.30
5
87.7
172.2
5
15KPA58A
15KPA58CA
58.0
64.80
5
93.8
161.0
5
15KPA60A
15KPA60CA
60.0
67.00
5
97.4
155.0
5
15KPA64A
15KPA64CA
64.0
71.50
5
104.2
144.9
5
15KPA70A
15KPA70CA
70.0
78.20
5
113.6
132.9
5
15KPA75A
15KPA75CA
75.0
83.80
5
122.0
123.8
5
15KPA78A
15KPA78CA
78.0
87.10
5
126.1
119.7
5
15KPA85A
15KPA85CA
85.0
94.90
5
137.6
109.7
5
15KPA90A
15KPA90CA
90.0
100.50
5
145.6
103.7
5
15KPA100A
15KPA100CA
100.0
111.70
5
161.3
93.6
5
15KPA110A
15KPA110CA
110.0
122.90
5
178.6
84.5
5
15KPA120A
15KPA120CA
120.0
134.00
5
192.3
78.5
5
15KPA130A
15KPA130CA
130.0
145.20
5
208.3
72.5
5
15KPA150A
15KPA150CA
150.0
167.60
5
241.9
62.4
5
15KPA160A
15KPA160CA
160.0
178.70
5
258.6
58.4
5
15KPA170A
15KPA170CA
170.0
189.90
5
272.7
55.4
5
15KPA180A
15KPA180CA
180.0
201.10
5
288.5
52.3
5
15KPA200A
15KPA200CA
200.0
223.40
5
319.1
47.3
5
15KPA220A
15KPA220CA
220.0
245.70
5
349.4
43.2
5
15KPA240A
15KPA240CA
240.0
268.10
5
384.6
39.3
5
15KPA260A
15KPA260CA
260.0
290.40
5
416.7
36.2
5
15KPA280A
15KPA280CA
280.0
312.80
5
454.5
33.2
5
Circuit Protection
System
5000
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:2
Transient Voltage Suppressors - 15KPA Series
Ratings and Characteristic Curves
Figure 1 - Peak Pulse Power Rating Curve
Figure 2 - Pulse Derating Curve
Figure 3 - Pulse Waveform
Figure 4 - Typical Junction Capacitance
Figure 5 - Steady State Power Derating Curve
Figure 6 - Maximum Non-Repetitive Peak Forward
Surge Current
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:3
Transient Voltage Suppressors - 15KPA Series
Soldering Parameters
Feflow Condition
Pre Heat
Lead-free assembly
- Temperature Min (T s(min))
150°C
- Temperature Max (T s(min))
200°C
- Time (min to max) (t s)
60-180 secs
Average ramp up rate (Liquidus Temp (TL) to peak
3°C/second max
TS(max) to TL - Ramp-up Rate
3°C/second max
- Temperature (T L) (Liquidus)
Reflow
217°C
- Time (min to max) (t s)
60-150 seconds
260+0/-5 °C
Peak Temperature (T P)
Time within 5°C of actual peak Temperature (t p)
20-40 seconds
Ramp-down Rate
6°C/second max
Time 25°C to peak Temperature (T P)
8 minutes Max.
Do not exceed
280°C
Physical Specifications
tp
TP
one
Critical Z P
TL to T
Ramp-up
Temperature (T)
TL
tL
Ts(max)
Ramp-down
Ts(min)
ts
Preheat
Time (t)
Weight
0.045oz., 1.2g
Case
JEDEC DO-201 molded plastic body over
passivated junction.
Polarity
Color band denotes the cathode except Bipolar.
Termina
Matte Tin axial leads, solderable per
JESD22-B102D.
Environmental Specifications
Flow/Wave Soldering
Temperature Cycle
JESD22-A104
Pressure Cooker
JESD 22-A102
Peak Temperature :
265°C
High Temp. Storage
JESD22-A103
Dipping Time :
10 seconds
HTRB
JESD22-A108
Soldering :
1 time
Thermal Shock
JESD22-A106
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:4
Transient Voltage Suppressors - 15KPA Series
Dimensions
Unit:mm
D
Inches
DIM
C
A
A
B
P600
Millimeters
Min
Max
Min
Max
A
1.000
-
25.40
-
B
0.340
0.360
8.60
9.10
C
0.048
0.052
1.22
1.32
D
0.340
0.360
8.60
9.10
Part Numbering System
15KPA xxx XX X
OPTION CODE:
BLANK Reel Tape
-B Bulk Packaging
TYPE CODE:
A Uni-Directional (5%Volt ageTolerance)
CA Bi-Directional
VOLTAGE CODE
(Refer to the Electrical Characteristics table)
SERIES CODE
Packaging
Part Number
Component
Package
Quantity
Packaging
Option
Packaging Specification
15KPAxxxXX
P600
400
Tape & Reel
ELA STD RS-296E
15KPAxxxXX-B
P600
100
BULK
Concord Packing Spec
Warehouse Storage Conditions of Products
· Storage Conditions:
1. Storage Temperature: -10°C~+40°C
2. Relative Humidity:≤75%RH
3. Keep away from corrosive atmosphere and sunlight.
· Period of Storage: 1 year
Circuit Protection
System
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:5
RuiLongYuan Electronics Co., Ltd.
· Reproducing and modifying information of the document is prohibited without permission from
Ruilongyuan International Inc.
· Ruilongyuan International Inc. reserves the rights to make changes of the content herein the document anytime
without notification. Please refer to our website for the latest document.
· Ruilongyuan International Inc. disclaims any and all liability arising out of the application or use of any product
including damages incidentally and consequentially occurred.
· Ruilongyuan International Inc. does not assume any and all implied warranties, including warranties of fitness
for particular purpose, non-infringement and merchantability.
· Applications shown on the herein document are examples of standard use and operation. Customers are responsible
in comprehending the suitable use in particular applications.Ruilongyuan International Inc. makes no representation or
warranty that such applications will be suitable for the specifed use without further testing or modifcation.
· The products shown herein are not designed and authorized for equipments requiring high level of reliability or relating to
human life and for any applications concerning life-saving or life-sustaining, such as medical instruments, transportation
equipment,aerospace machinery et cetera. Customers using or selling these products for use in such applications do so at
their own risk and agree to fullyindemnify Ruilongyuan International Inc. for any damages resulting from such improper use or
sale.
Tel: +86-755-8290 8296
Circuit Protection
System
Fax: +86-755-8290 8002
E-mail: [email protected]
Specifications are subject to change without notice.
Please refer to http://www.ruilon.com for current information.
Page:6