Axial Lead Transient Voltage Suppressors (TVS) 15KPA Series 17 To 280 V 15000W Uni-directional Description Bi-directional The 15KPA series is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. Features u u u u u u u u u u u u u u u u u Glass passivated chip junction in P600 Package Low leakage Uni and Bidirectional unit Excellent clamping capability 15000W Peak power capability at 10 × 1000µs waveform Repetition rate (duty cycle):0.01% Fast response time: typically less than 1.0ps from 0 Volts to VBR min Typical IR less than 2μA above 40V. High Temperature soldering: 260°C/40 seconds at terminals Typical maximum temperature coefficient ΔVBR = 0.1% × VBR@25°C× ΔT Plastic package has Underwriters Laboratory Flammability 94V-0 Matte tin lead–free Plated Halogen free and RoHS compliant Typical failure mode is short from over-specified voltage or current Whisker test is conducted based on JEDEC JESD201A per its table 4a and 4c IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact) ESD protection of data lines in accordance with IEC 61000-4-2 (IEC801-2) EFT protection of data lines in accordance with IEC 61000-4-4 (IEC801-4) Functional Diagram Bi-directional Cathode Anode Uni-direction Applications TVS devices are ideal for the protection of I/O interfaces, VCC bus and other vulnerable circuits used in Telecom, Computer, Industrial and Consumer electronic applications. Maximum Ratings (TA=25℃ unless otherwise noted) Parameter Symbol Value Unit Peak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note 1), (Note 2) PPPM 15000 Watts IPP See Next Table Amps PM(AV) 8.0 Watt IFSM 500 Amps TJ , TSTG -55 to +150 °C Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3) Power Dissipation on Infinite Heat Sink at TL=75°C Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3) Operating junction and Storage Temperature Range. Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25°C per Fig. 2. 2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal. 3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum. 4. VF < 3.5V for VBR < 200V and VF< 6.5V for VBR > 201V. SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 1/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 15KPA Series 17 To 280 V 15000W Electrical Characteristics (TA=25℃ unless otherwise noted) Part Number Bi 15KPA17A 15KPA17CA 15KPA18A 15KPA18CA 15KPA20A Breakdown Voltage VBR (V) @IT Test Current IT (mA) Maximum Clamping Voltage VC @IPP (V) Maximum Peak Pulse Current IPP (A) Maximum Reverse Leakage IR @VRWM (μA) MIN MAX 17 18.99 20.79 50 29.3 515.4 5000 18 20.11 22.01 50 30.9 488.7 5000 15KPA20CA 20 22.34 24.46 20 34.3 440.2 1500 15KPA22A 15KPA22CA 22 24.57 26.91 10 37.1 407.0 500 15KPA24A 15KPA24CA 24 26.81 29.35 5 40.7 371.0 150 15KPA26A 15KPA26CA 26 29.04 31.80 5 44.0 343.2 50 15KPA28A 15KPA28CA 28 31.28 34.24 5 47.5 317.9 25 15KPA30A 15KPA30CA 30 33.51 36.70 5 50.7 297.8 15 15KPA33A 15KPA33CA 33 36.90 40.40 5 54.7 276.1 2 15KPA36A 15KPA36CA 36 40.20 44.00 5 59.8 252.5 2 15KPA40A 15KPA40CA 40 44.70 48.90 5 65.8 229.5 2 15KPA43A 15KPA43CA 43 48.00 52.60 5 69.8 216.3 2 15KPA45A 15KPA45CA 45 50.30 55.00 5 72.8 207.4 2 15KPA48A 15KPA48CA 48 53.60 58.70 5 77.7 194.3 2 15KPA51A 15KPA51CA 51 57.00 62.40 5 82.9 182.1 2 15KPA54A 15KPA54CA 54 60.30 66.00 5 87.7 172.2 2 15KPA58A 15KPA58CA 58 64.80 70.90 5 93.8 161.0 2 15KPA60A 15KPA60CA 60 67.00 73.40 5 97.4 155.0 2 15KPA64A 15KPA64CA 64 71.50 78.30 5 104.2 144.9 2 15KPA70A 15KPA70CA 70 78.20 85.60 5 113.6 132.9 2 15KPA75A 15KPA75CA 75 83.80 91.70 5 122.0 123.8 2 15KPA78A 15KPA78CA 78 87.10 95.40 5 126.1 119.7 2 15KPA85A 15KPA85CA 85 94.90 104.00 5 137.6 109.7 2 15KPA90A 15KPA90CA 90 100.50 110.10 5 145.6 103.7 2 15KPA100A 15KPA100CA 100 111.70 122.30 5 161.3 93.6 2 15KPA110A 15KPA110CA 110 122.90 134.50 5 178.6 84.5 2 15KPA120A 15KPA120CA 120 134.00 146.80 5 192.3 78.5 2 15KPA130A 15KPA130CA 130 145.20 159.00 5 208.3 72.5 2 15KPA150A 15KPA150CA 150 167.60 183.50 5 241.9 62.4 2 15KPA160A 15KPA160CA 160 178.70 195.70 5 258.6 58.4 2 15KPA170A 15KPA170CA 170 189.90 207.90 5 272.7 55.4 2 15KPA180A 15KPA180CA 180 201.10 220.10 5 288.5 52.3 2 15KPA200A 15KPA200CA 200 223.40 244.60 5 319.1 47.3 2 15KPA220A 15KPA220CA 220 245.70 269.10 5 428.6 42.2 2 15KPA240A 15KPA240CA 240 268.10 293.50 5 384.6 39.3 2 15KPA260A 15KPA260CA 260 290.40 318.00 5 416.7 36.2 2 15KPA280A Note: 15KPA280CA 280 312.80 342.40 5 454.5 33.2 2 1. Uni Reverse Stand-Off Voltage VRWM (V) For Bi-Directional devices having VR of 30 volts and under, the IR limit is double SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 2/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 15KPA Series 17 To 280 V 15000W Ratings and Characteristic Curves (TA=25°C unless otherwise noted) Figure 1 - Peak Pulse Power Rating Curve Figure 2 - Pulse Derating Curve Peak Pulse Power (PPP) or Current (IPP) Derating in Percentage % PPPM - Peak Pulse Power (kW) 1000 100 10 0.1 0.1 10 100 td - Pulse Width (μs) 60 40 20 0 0 25 50 75 100 125 150 175 TA-Ambient temperature(°C) 200 Figure 4 - Typical Junction Capacitance 1000000 150 tr=10µsec Peak Value IPPM TJ=25°C Pulse Width(td) is defined as the point where the peak current decays to 50% of IPPM CJ – Junction Capacitance (pF) IPPM - Peak Pulse Current, % IRSM 80 1000 Figure 3 - Pulse Waveform 100 Half Value IPPM (IPPM/2) 50 10/1000µsec. Waveform as defined by R.E.A tc 0 0 Bi-directional @zero bins Uni-directional @zero bins 10000 Uni-directional @VRWM 100 Bi-directional @VRWM Tj=25°C f=1.0MHz Vsig=50mVp-p 1 1.0 2.0 t - Time (ms) 3.0 0 4.0 Figure 5 - Steady State Power Derating Curve 50 100 150 200 250 300 VBR-Reverse Breakdown Voltage (V) 350 Figure 6 - Maximum Non-Repetitive Surge Current 500 8.0 IFSM-Peak Forward Surge Current (A) PM(AV), Steady State Power Dissipation (W) 100 7.0 6.0 5.0 4.0 3.0 2.0 1.0 TJ=TJ max. 8.3 ms Single Half Sine-Wave 450 400 350 300 250 200 0.0 0 25 50 75 100 125 150 TL - Lead Temperature(°C) 175 1 200 SOCAY Electronics Co., Ltd. Revision September 25, 2013 10 Number of Cycles at 60Hz 100 www.socay.com 3/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 15KPA Series 17 To 280 V 15000W I-V Curve Characteristics Physical Specifications Environmental Specifications Weight 0.07 ounce, 2.1gram Temperature Cycle JESD22-A104 Case JEDEC R-6/P600 Molded Plastic over glass passivated junction Pressure Cooker JESD22-A102 High Temp. Storage JESD22-A103 HTRB JESD22-A108 Thermal Shock JESD22-A106 Color band denotes cathode except Bipolar Matte Tin-plated leads, Solderable per JESD22-B102D Polarity Terminal Soldering Parameters Reflow Condition Lead–free assembly TP Ramp-up Critical Zone TL to TP TL Pre Heat -Temperature Min (Ts(min)) 150°C -Temperature Max (Ts(max)) 200°C - Time (min to max) (Ts) 60 -180 Seconds Temperature TS(max) Ramp-down TS(min) Average ramp up rate ( Liquidus Temp TL) to peak 3°C/second max TS(max) to TL - Ramp-up Rate 3°C/second max Preheat Time to peak temperature (t 25℃ to peak) - Temperature (TL) (Liquidus) 217°C - Time (min to max) (TL) 60 -150 Seconds Reflow 25 Time Peak Temperature (TP) Time within 5°C Temperature (tp) SOCAY Electronics Co., Ltd. Revision September 25, 2013 260 +0/-5°C of actual peak 20 -40 Seconds Ramp-down Rate 6°C/second max Time 25°C to peak Temperature (TP) 8 minutes Max Do not exceed 280°C www.socay.com 4/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 15KPA Series 17 To 280 V 15000W Dimensions Inches R6/P600 Millimeters Dimensions Min Max Min Max A 1.000 - 25.40 - B 0.340 0.360 8.64 9.14 C 0.048 0.052 1.22 1.32 D 0.340 0.360 8.64 9.14 Cathode Band Part Marking Part Numbering 15KP×××CA Cathode Band Socay Logo 5% VBR VOLTAGE TOLERANCE 15KPXXX BI-DIRECTIONAL Product Type VR VOLTAGE SERIES Packaging Part Number Component Package 15KPXXXXX Packaging Dimensions R6/P600 Quantity Packaging Option 200 Box Unit: Inches (Millimeters) 2.56 (65.00) 0.25 (6.35) 0.40±0.020 (10.16±0.508) SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 5/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information.