Screw Clamp Connections RSF 3 RSF 1 Spring Loaded Available Options Molding material Dimensions Width / Length / Height mm (in.) Part No. 0497560000 9501160000 Version TS 32 Polyamide TS 35 Polyamide TS 32 Melamlne with TS 32 Insulating stripping length Technical Data Rated voltage / rated current / wire size mm (in.) UL CSA Terminal Rail (2 m) Steel Steel (M6 Slots) Locking pin (1 m)—optional End Bracket (thickness mm) Steel Part No. 0270320000 8/50/60 (.31/1.97/2.36) 11/50/60 (.43/1.97/2.36) 12 (.47) 12 (.47) 600 V / 25 A / #22…12 AWG 600 V / 25 A / #22…12 AWG Type TS 32 TS 32 Part No. 0122800000 0676100000 600 V / 40 A / #14…8 AWG 300 V / 50 A / #14…8 AWG Type TS 32 TS 32 Part No. 0122800000 0676100000 SST 3 0152700000 SST 3 0152700000 EWK 1 (8.5) 0206160000 EWK l (85) 0206160000 AP (3) 0270460000 AP (3) 0270420000 End Plate (thickness mm) Polyamide Melamine Partition (thickness mm) Small partition Jumper Polyamide TW (1.5) 3877960000 Resin bonded paper Resin bonded paper Polyamide TW (2) TW (0.5) TSch 1 3833500000 0474700000 0319160000 TW (2) TW (0.5) 3833500000 0474700000 QL 2 QL 3 QL 4 QL 10 VH 13.5 BS (M3 x 20) 0194300000 0194400000 0194500000 0338300000 0248500000 0303000000 QL 2 QL 3 QL 4 QL 10 VH 17.5 BS (M3 x 25) SS 0267400000 0267500000 0267600000 0341700000 0285200000 0292500000 0164400000 VL 2 VH 27 BS (M3 x 35) 0528400000 0309400000 0309800000 Note: Final number in model indicates no. of poles (e.g. QL 2 = 2 poles). For additional information, see Accessories section. Sleeve Screw Washer Switching Link 2-way Sleeve Screw Test Plugs Plug Plug bolt PS (2.3Ø) StB 14 0180400000 0168600000 PS (4Ø) StB 18 0299600000 0286500000 ADP 2 HP 2 0485300000 0485660000 ADP 2 HP 2 0485300000 0485660000 Cover (1 m) Transparent cover Support bracket Hooked Blade Crimp* 9100500000 9100600000 #22…16 AWG #16…14 AWG #12…10 AWG Marking Tags All marking systems are shown in Accessories Section. 176 DEK 5/8 DEK 5/8 1653340001 1653350001 9100200000 9100300000 9100400000 DEK 5/8 DEK 5/8 1653340001 1653350001 *To accommodate two hooked bladed crimps back-to-back per terminal, one should be located in the current bar slot, the second through the lower part of the clamp.