ETC AT-202

Voltage Variable Absorptive Attenuator
DC - 5 GHz
AT-202
V 2.00
CR-3
Features
●
●
●
Fast Switching Speed, 4 ns Typical
Ultra Low Dc Power Consumption
Small Package Size, 0.180” (4.6mm) Sq
Guaranteed Specifications *
(From -55°C to +85°C)
Frequency Range
Insertion Loss
DC - 5 GHz
DC - 3 GHz
DC - 2 GHz
DC - 5 GHz
2.0 dB Max
1.5 dB Max
1.5 dB Max
VSWR
DC - 5 GHz
DC - 3 GHz
DC - 2 GHz
2.0:1 dBMax
1.5:1 dB Max
1.5:1 dB Max
Attenuation
DC - 4 GHz
DC - 5 GHz
20 dB Max
18 dB Max
*DC - 5 GHz
2.5 dB Max
1.5 dB Max
1.0 dB Max
Flatness
(Peak to Peak)
Attenuation vs. Temperature
DC - 3 GHz
DC - 2 GHz
0 to 10 dB Att.
20 dB Att.
Dimensions in ( ) are in mm.
Bottom of Case is AC Ground.
Typical Performance
+85°C
+25°C
-55°C
±0.6 dB
±2.5 dB
30 dB attn.
0 dB attn.
* To 15 dB attenuation
Operating Characteristics
Impedance
50 Ohms Nominal
Switching Characteristics
Trise, Tfall (10% to 90%)
Ton, Toff (50% C+L to 90%/10% RF)
Transients (in band)
4 ns Typ
8 ns Typ
10 mv Typ
Input Power for 1 dB Compression
Attenuation Level
0 dB
.05 GHz to 5 GHz
+16
Intermodulation Intercept Point
(for two-tone input power up to +5 dBm)
Intercept Points
IP2
.05 GHz to 5 GHz
+25
Control Voltages
A Input (Shunt FETS)
B Input (Series FETS)
20 dB
+11
dBm Typ
IP3
+13
dBm Typ
SERIES
B Input
SHUNT
A Input
-1.5 to -4V @ 100 µAMax
0 to -4V @ 100 µAMax
Environmental
See Appendix for MIL-STD-883 screening option.
* All specifications apply with 50 ohm connected to all RF ports.
† Faster switching speed can be achieved with enhanced driver waveform.
Switching speed is measured between 20 dB and 2 dB attenuation levels.
Ordering Information
Model No.
AT-202 PIN
Package
Ceramic
Pin Configuration
GND
PIN ORIENTATION MARK
RF1
A
GND
B
GND
GND
RF2