ETC TUA6100

P
R O D U C T
B
R I E F
The TUA 6100 direct down conversion tuner IC in
BICMOS technology combines bipolar analog
functions with a CMOS-PLL on one chip. This
integration reduces external discrete components
(SAW filter) and provides the potential to reduce
the cost. Our TSSOP-28 package saves PCBboard space. The tuner IC is suitable for multimedia applications like DVB/DSS systems (set-top
boxes, PC card receiver) and new applications,
such as digital SAT TV sets and digital VCRs.
Next generation DCR IC in development - goes for
higher integration and smaller package (VQFN).
Potential Application
■ Digital set-top box (DVB, DSS)
■ VCR digital (satellite-ready)
■ TV (satellite-ready)
■ PC card receiver
Features
■ Low impendance gain controlled RF input
■ Dual matched double balanced
mixer
■ Digital generation of 0°/90° LO
signal
■ Direct down conversion from
1. IF (LNB output) to baseband
■ IF filter not necessary
■ I/O for external basebandfilter
■ CMOS PLL-Synthesizer
■ Active loopfilter
■ 3 high current switch outputs
■ Low noise reference voltage
2
■ 3-wire-Bus/I C-Bus
■ P-TSSOP-28 package
■ Buffered Xtal output
TUA 6100
Price projection
■ Standard price list
■ For Key and Focus accounts or
high volumes you may contact
your regional Infineon sales
partner
Features
Benefits
Direct down conversion from 1. IF to Fully integrated single-chip frontend
baseband
CMOS PLL-Synthesizer
On board low phase noise PLL
solution
IF filter not necessary
Lower BOM-SAW filter eliminated
Two bus systems available
2
3-wire-Bus / I C-Bus
P-TSSOP-28 package
Packing
Type
TUA 6100
Small package - space saving
Ordering Code Package
Q67037-A1034P P-TSSOP-28
Infineon NIM
Module
Infineon/STM
NIM Module
Q6703-A1151
Availability
MP Q3/2000
for key accounts
ES Q2/2000
Q3/2000
Q6703-A1152
Q3/2000
MP = Mass Production
T U A
Development and Support Tools
■ NIM Module for Satellite
Frontend
■ Evaluation Board TUA 6100
■ PLL Programming Kit for
Windows (16 Bit)
ES = Engineering Sample
6 1 0 0
Direct Conversion Tuner IC for
Digital Satellite Receiption
N e v e r
s t o p
t h i n k i n g .
P
R O D U C T
B
R I E F
TUA 6100
Block Diagram
I
fIN =
950...2150 MHz
90˚
Q
0˚
÷2
÷2
÷n
ϕ
PLL
AGC
Documentation
Date of Issue/Version
Specification
05/00
Application/Measurement
05/00
Infineon Strength
Complete DCR solution with fitting
feature size
■ TUA 6100: PLL on chip
■ SQP 6186: DISEqC 2.x, SCPC/
MCPC range 1...45 MSymb/s,
2150
-950 MHz
analog filtering on board, integrated AGC + equalizer
Cost savings due to unnecessary external filtering
Interface to other demodulator
tested - NIM module available
■
■
DCR Tuner
Demodulator
Ι
TUA 6100
SQP 6186
Transport
Stream
TUA 6100
Application Example
Q
How to reach us:
http://www.infineon.com
Attention please!
The information herein is given to describe certain components
and shall not be considered as warranted characteristics.
Published by
Infineon Technologies AG,
Bereich Kommunikation,
St.-Martin-Strasse 53,
D-81541 München
Terms of delivery and rights to technical change reserved.
© Infineon Technologies AG 2000. All Rights Reserved.
Infineon Technologies is an approved CECC manufacturer.
We hereby disclaim any and all warranties, including but not
limited to warranties of non-infringement, regarding circuits,
descriptions and charts stated herein.
Information
For further information on technology, delivery terms and
conditions and prices please contact your nearest
Infineon Technologies Office in Germany or our Infineon
Technologies Representatives worldwide.
Published by Infineon Technologies AG
Warnings
Due to technical requirements components may contain dangerous substances. For information on the types in question
please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in lifesupport devices or systems with the express written approval
of Infineon Technologies, if a failure of such components can
reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness
of that device or system. Life support devices or systems are
intended to be implanted in the human body, or to support
and/or maintain and sustain and/or protect human life. If they
fail, it is reasonable to assume that the health of the user or
other persons may be endangered.
Ordering No. B168-H7368-G3-X-7600
Printed in Germany
PS 04005.
NB