Product Brief BlueMoon Single Cellular PMB 8761 B l u e M o o n ® S i n g l e C e l l u l a r is the optimized Bluetooth ® wireless solution for cost-sensitive cellular phone applications. The advanced architecture out of the BlueMoon Single family combines minimal power consumption with excellent RF performance. The high integration level and a cost efficient VQFN package result in an extremely low board area of less than 80 mm² and industry leading cost of ownership. Being compliant to Bluetooth Standard 1.2 BlueMoon Single Cellular is a reliable solution for the mobile future. Key Features ■ ■ ■ ■ ■ Applications ■ ■ ■ ■ ■ ■ ■ Headset and Handsfree Dial-up networking Data transfer (e.g. object push) Synchronization Cordless telephony Advanced audio ■ ■ ■ ■ Bluetooth 1.2 Support – Extended SCO – Adaptive frequency hopping – Fast connection setup Integrated ROM for lowest cost Programmable power-down mode Clock input for joint use with GSM/CDMA/3G clocks (11.5 to 46 MHz) Full automatic tuning and trimming (no manual or SW tuning) High RF sensitivity (-85 dBm @ 0.1% BER) On-chip 2.4 GHz RF driver amplifier with max. +7 dBm output power Automatic control of output power for reduced power consumption Compatible to available GSM/GPRS/CDMA base band solutions P-VQFN-48 package (lead-free/halogen-free) Key Benefits ■ ■ ■ True single chip Low power consumption Smallest size, highest integration, lowest BoM Note: The Bluetooth word mark is owned by the Bluetooth SIG, Inc. and any use of this mark by Infineon Technologies AG is under license. The BlueMoon trade mark is owned by Infineon Technologies AG. www.infineon.com/bluetooth Wireless Communication N e v e r s t o p t h i n k i n g . Product Brief Block Diagram ■ PMB 8761 Baseband ■ 2.4 GHz Radio Transceiver ■ ■ Power Mgmt PLL Clocks RF Interface PLL and Control Logic Transmit Buffer 1/3, 2/3 FEC Data Whitening x2 Internal ROM CVSD/ PCM 1/3, 2/3 FEC Clock Recovery Sliding Correlator Offset Canceller Demod A/D (RSSI) S&H ■ ■ ■ ■ PD UART (2, 4 wired) PCM (A-law, µ-law) External oscillator Control lines for Class 1 PA Wake up line External 32 kHz low power oscillator Integrated RF switch Prescaler N/A LNA GSM Antenna Voice in/out Link Controller PCM Power Management ROM SMARTi-DC+ Low IF Receiver BlueMoon Single Cellular S-GOLD UART1 UARTIN UARTOUT Tx Rx RF Interface 26 MHz Osc. DAI 500 kHz SCLK TxDD TFSD RxDD RFSD PCMCLK PCMIN PCMFR PCMOUT WAKEUP_HOST VDDUART VDDPCM VDDPM Application Example Mobile Phone with Bluetooth Due to its small package size and because of few external components, BlueMoon Single Cellular is the perfect IC solution for Bluetooth enabled cell phones. In this example, the BlueMoon Single Cellular is built into a GSM mobile phone design based on Infineon‘s cellular ICs. This solution perfectly meets cost and size requirements of the final product. 32.768 kHz 26 MHz Supply SLEEPX CLK32 WAKEUP_BT Supply Bluetooth Antenna UART 11.5 ... 46 MHz active only Data in/out Receive Buffer Clock enable SM-Power How to reach us: http://www.infineon.com Published by Infineon Technologies AG, St.-Martin-Strasse 53, D-81669 München © Infineon Technologies AG 2004. All Rights Reserved. Template: pb_tmplt.fm/4/2004-01-01 Published by Infineon Technologies AG Clock enable 1.8 V Permanent PCM Reference Level UART Reference Level Attention please! The information herein is given to describe certain components and shall not be considered as a guarantee of characteristics. Terms of delivery and rights to technical change reserved. We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and charts stated herein. Information For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office. Warnings Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office. Infineon Technologies Components may only be used in lifesupport devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered. Ordering No. B114-H7988-G1-X-7600 Printed in Germany PS 0204.5 NB