ALUMINUM ELECTROLYTIC CAPACITORS HD Approved by Reliability Center for Electronic Component, Japan-Certification No. RCJ-03-23C High Ripple Low Impedance series Laminated case series. Lower impedance at high frequency range. Smaller case size and high ripple current. HC HD Low Impedance Specifications Performance Characteristics ltem Category Temperature Range — 40 ~ + 105˚C Rated Voltage Range 6.3 ~ 50V Rated Capacitance Range 22 ~ 6800µF Capacitance Tolerance ±20% at 120Hz, 20˚C Leakage Current After 2 minutes' application of rated voltage, leakage current is not more than 0.01CV or 3(µ A), whichever is greater. Rated voltage (V) 6.3 10 16 25 35 50 tanδ (MAX.) 0.22 0.19 0.16 0.14 0.12 0.10 tan δ 120Hz 20˚C For capacitance of more than 1000µF, add 0.02 for every increase of 1000µF. Rated voltage (V) Stability at Low Temperature Impedance ratio ZT/Z20(MAX.) 6.3 10 16 25 35 50 Z— 25˚C/Z + 20˚C 2 2 2 2 2 2 Z— 40˚C/Z + 20˚C 3 3 3 3 3 3 After an application of D.C. bias voltage plus the rated ripple current for 5000 hours (φD 120Hz 6.3 : 2000 hours, φD=8 : 3000 hours, φD=10 : 4000 hours) at 105˚C the peak voltage shall not exceed the rated D.C. voltage, capacitors meet the characteristics requirements listed below. Endurance Marking Capacitance change Within ±25% of initial value tanδ 200% or less of initial specified value Leakage current lnitial specified value or less Black print on the case top. Type numbering system (Example : 10V 3300µF) Radial Lead Type φd tinned CP wire Laminated case 1 2 3 4 5 6 7 8 9 10 11 12 U HD 1 A 3 3 2 M HR Size code P±0.5 φD+0.5 MAX H9904 Voltage Lot No. 3300 HD 10V nic hicon Trade mark Capacitance tolerance(±20%) Rated Capacitance(3300µF) Series Capacitance Pressure relief vent (φ6.3up) Configuration Rated voltage(10V) L+ 15MIN MAX 4MIN Series name φD Code 5 DR 6.3 ER 8 •10 PR 12.5•16 HR Type (mm) (L<20) 1.5 (L 20) 2.0 φD 5 6.3 8 10 12.5 16 P 2.0 2.5 3.5 5.0 5.0 7.5 φd 0.5 0.5 0.6 0.6 0.6 0.8 In case L> 25 for the φ12.5 dia.unit, lead dia.φd=0.8mm Please refer to page 18, 19, 20 about the formed or taped product spec. Please refer to page 3 for the minimum order quantity. Dimension table in next pages. CAT.8100P ALUMINUM ELECTROLYTIC CAPACITORS HD series Standard ratings V(Code) Item Cap.(µF) Code 6.3(0J) Case size φD × L (mm) 10(1A) Impedance(ΩMAX.) 20˚C/100kHz — 10˚C/100kHz Rated ripple (mA rms) 105˚C/100kHz 100 101 150 151 220 221 330 331 470 471 560 561 680 681 820 821 8 ×15 0.056 0.17 995 1000 102 10 ×12.5 0.053 0.16 1030 8 ×20 0.041 0.13 1250 10 ×16 0.038 0.12 1430 5 ×11 0.30 1.0 250 6.3 ×11 0.13 0.41 405 0.072 0.22 760 8 ×11.5 Case size φD × L (mm) Impedance(ΩMAX.) 20˚C/100kHz — 10˚C/100kHz Rated ripple (mA rms) 105˚C/100kHz 5 ×11 0.30 1.0 250 6.3 ×11 0.13 0.41 405 8 ×11.5 0.072 0.22 760 8 ×15 0.056 0.17 995 10 ×12.5 0.053 0.16 1030 8 ×20 0.041 0.13 1250 10 ×16 0.038 0.12 1430 10 ×20 0.023 0.069 1820 1200 122 1500 152 10 ×20 0.023 0.069 1820 10 ×25 0.022 0.066 2150 2200 222 10 ×25 0.022 0.066 2150 12.5 ×20 0.021 0.053 2360 3300 332 12.5 ×20 0.021 0.053 2360 12.5 ×25 0.018 0.045 2770 12.5 ×31.5 0.016 0.041 3290 16 ×20 0.018 0.045 3140 3900 392 12.5 ×25 0.018 0.045 2770 4700 472 12.5 ×31.5 0.016 0.041 3290 12.5 ×35.5 0.015 0.039 3400 12.5 ×35.5 0.015 0.039 3400 16 ×20 0.018 0.045 3140 16 ×25 0.016 0.043 3460 16 ×25 0.016 0.043 3460 5600 562 6800 682 V(Code) Item Cap.(µF) Code 47 470 56 560 100 101 120 121 220 221 330 331 470 471 680 681 16(1C) Case size φD × L (mm) 25(1E) Impedance(ΩMAX.) 20˚C/100kHz — 10˚C/100kHz Rated ripple (mA rms) 105˚C/100kHz 5 ×11 0.30 1.0 250 6.3 ×11 0.13 0.41 405 8 ×11.5 0.072 0.22 760 0.30 1.0 250 6.3 ×11 0.13 0.41 405 8 ×11.5 0.072 0.22 760 8 ×15 0.056 0.17 995 10 ×12.5 0.053 0.16 1030 0.17 995 8 ×20 0.041 0.13 1250 0.053 0.16 1030 10 ×16 0.038 0.12 1430 8 ×20 0.041 0.13 1250 10 ×16 0.038 0.12 1430 10 ×20 0.023 0.069 1820 102 10 ×20 0.023 0.069 1820 1200 122 10 ×25 0.022 0.066 2150 1500 152 12.5 ×20 0.021 0.053 2360 222 — 10˚C/100kHz 5 ×11 0.056 821 2200 20˚C/100kHz Rated ripple (mA rms) 105˚C/100kHz 8 ×15 820 182 Impedance(ΩMAX.) 10 ×12.5 1000 1800 Case size φD × L (mm) 10 ×25 0.022 0.066 2150 12.5 ×20 0.021 0.053 2360 12.5 ×25 0.018 0.045 2770 12.5 ×31.5 0.016 0.041 3290 16 ×20 0.018 0.045 3140 12.5 ×25 0.018 0.045 2770 12.5 ×35.5 0.015 0.039 3400 12.5 ×31.5 0.016 0.041 3290 16 ×20 0.018 0.045 3140 16 ×25 0.016 0.043 3460 2700 272 3300 332 12.5 ×35.5 0.015 0.039 3400 3900 392 16 ×25 0.016 0.043 3460 : In this case, 6 will be put at 12th digit of type numbering system. CAT.8100P ALUMINUM ELECTROLYTIC CAPACITORS HD series Standard ratings V(Code) Item Cap.(µF) Code 35(1V) Case size φD × L (mm) 50(1H) Impedance(ΩMAX.) 20˚C/100kHz — 10˚C/100kHz Rated ripple (mA rms) 105˚C/100kHz 22 220 33 330 5 ×11 0.30 1.0 250 6.3 ×11 0.13 0.41 405 Case size φD × L (mm) Impedance(ΩMAX.) Rated ripple (mA rms) 105˚C/100kHz 20˚C/100kHz — 10˚C/100kHz 5 ×11 0.34 1.18 238 6.3 ×11 56 560 0.14 0.50 385 100 101 8 ×11.5 0.074 0.22 724 120 121 8 ×15 0.061 0.18 950 150 151 10 ×12.5 0.061 0.18 979 180 181 8 ×20 0.046 0.14 1190 220 221 10 ×16 0.042 0.12 1370 270 330 8 ×11.5 0.072 0.22 760 8 ×15 0.056 0.17 995 10 ×12.5 0.053 0.16 1030 271 8 ×20 0.041 0.13 1250 10 ×20 0.030 0.090 1580 331 10 ×16 0.038 0.12 1430 10 ×25 0.028 0.085 1870 470 471 10 ×20 0.023 0.069 1820 12.5 ×20 0.027 0.068 2050 560 561 10 ×25 0.022 0.066 2150 12.5 ×25 0.023 0.059 2410 680 681 12.5 ×20 0.021 0.053 2360 12.5 ×31.5 0.021 0.052 2860 12.5 ×35.5 0.019 0.051 2960 16 ×20 0.023 0.059 2730 16 ×25 0.021 0.056 3010 820 821 1000 102 12.5 ×25 0.018 0.045 2770 12.5 ×31.5 0.016 0.041 3290 1200 122 16 ×20 0.018 0.045 3140 1500 152 12.5 ×35.5 0.015 0.039 3400 1800 182 16 ×25 0.016 0.043 3460 : In this case, 6 will be put at 12th digit of type numbering system. Frequency coefficient of rated ripple current Frequency 50Hz 120Hz 1kHz 10kHz 100kHz 22 ~ 33 0.45 0.55 0.75 0.90 1.00 39 ~ 330 0.60 0.70 0.85 0.95 1.00 390 ~ 1000 0.65 0.75 0.90 0.98 1.00 1200 ~ 6800 0.75 0.80 0.95 1.00 1.00 Cap.(µF) CAT.8100P