NTE303 Thermal Compound, 1 Gram/Tube Technical Specifications: (Typical) Material Description Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Silicon Oil Filler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Zinc Oxide and Silica Color . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . White Serviceable Range, °F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –40 to 400 Specific Gravity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.3 minimum Thermal Conductivity, (K factor, cal/cm2/°C/sec/cm) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.001 Physical Properties Consistency Worked Penetration (60 strokes) @ 77°F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250–330 Brookfield Viscosity (spindle #7; 1 rpm; 4th rev. @ 77°F) . . . . . . . . . . . . . . . . . . . . 1.1 – 1.6 mil cps. Bleed; % max. after 24 hrs, @ 200°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0 Evaporation; % max., after 24 hrs @ 200°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0 Material Safety Data Sheet: Section I Distributor: Address: Century Lubricants Co. 2140 S. 88th Street Kansas City, KS 66111–8701 Revision Date: 1–18–96 HPC11 DOC 498 188002–AA Telephone: Chem Trec: 913–791–3645 800–424–9300 Prepared By: M. D. Hart Section II (Chemical and Physical Properties) Solubility in Water (@ 20°C): NIL Specific Gravity (Water = 1): > 1.0 Vapor Pressure (mmHg @ 20°C): NIL Evaporation Rate (Ether = 1): < 0.001 Percent Volatile (By Weight): ZERO Appearance and Odor: White Gel, Odorless Vapor Density (Air = 1): Strong Acid: Strong Base: Boiling Point (°F): Melting Point (°F): >1 NO NO +600°F N/A Section III (Reactivity Data) Stability: Stable Incompatibility: Keep Away From Strong Oxidizers Note: Hazardous Polymerization Will Not Occur Section IV (Fire and Explosion Data) Flash Point (Method): 600°F Min Flammable Limits – LEL: UNK UEL: UNK Extinguishing Agents: Dry Chemical (X) C02 (X) Water Spray (X) Foam (X) Special Fire Fighting Procedures: Avoid breathing vapors. Use breathing apparatus in confined areas. Cool exposed containers with water spray. Hazardous Thermal Decomposition Product: Silicon dioxide, carbon oxides, formaldehyde, unidentified organic compounds Section V (Precautions for Safe Handling and Use) Steps to Take in Case of Spill: Add absorbent to spill area. Keep silicone products out of sewers and waterways. Advise authorities if they do enter. Waste Disposal Method: Dispose of at appropriate waste facility in accordance with regulations. Precautions in Storage: Keep containers closed when not in use. Do not handle near heat, flames, sparks. Do not weld or heat empty containers. Section VI (Health Hazard Data) Permissible Concentrations (Air): None Established Route Effect of Overexposure Emergency First Aid Procedure Eyes None Expected Flush with water. See physician. Skin Prolonged or repeated contact may Wash with soap and water. If high pressure, cause mild irritation get immediate medical attention. Inhalation None Expected Ingestion None Expected Chronic None Expected Remove from contaminated area. Material Safety Data Sheet (Cont’d): Section VI (Health Hazard Data) Hazardous Ingredients TLV, TWA, PEL Silica Thickner PEL 20 MPPCF (As Dust) Zinc Compound * < 80% TWA 5 MG/M3 (As Dust) IARC, NTP, OSHA Not Listed Not Listed Section VII (Control Measures) Respiration Protection: None Normally Needed Ventilation Type: General adequate. Use local mechanical to insure TLV’s not surpassed where applicable. Skin Protection: Chemically Resistance Desirable Eye Protection: Goggles or Faceshield Desirable Other Protective Measures: None normally needed. Section VIII (Miscellaneous) UNK means Unknown EST means Estimated N/A means Not Applicable * This component is regulated under Section 313 of SARA The information contained herein is based on data considered accurate. However, no warranty, expressed or implied, is given regarding the accuracy of this data or the result to be obtained from the use thereof.