RL28-55/82b/105/... Reflection light beam switch with polarisation filter RL28-55/82b/105/... with 5-pin, M12 x 1 plastic connector U ® K Detection range up to 16 m K PNP and NPN transistor outputs K Clearly visible LEDs for Power ON, switching state and stability control K Sensitivity adjuster and light/dark switch as standard features of this series K Not sensitive to ambient light, even with energy saving lamps K Dove-tail mounts and pass-through mounting holes K Large temperature range from -40 °C ... +60 °C Date of issue: 10/4/01 Series 28 K Waterproof, protection class IP67 For suitable cable sockets, reflectors and mounting aids refer to chapter "accessories". Subject to reasonable modifications due to technical advances. 1 Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com Effective detection range Threshold detection range Reflector distance Light type Light source Angle of divergence Diameter of the light spot Ambient light limit Standard conformity Approvals USA Kanada Operating display Function display Controls Controls Operating voltage Ripple No-load supply current Signal output Switching type Switching voltage Switching current Switching frequency Response time Output of the pre-fault indication 1 npn, 1 pnp synchronised-switching, short-circuit proof, protected against reverse polarity 1 push-pull output, short-circuit proof, protected against reverse polarity Light/dark ON, switchable max. 30 V DC max. 200 mA 1000 Hz 0.5 ms 1 pnp, inactive when falling short of the stability control for 10 s immediately inactive if 4 light beam interruptions take place -40 ... +60 °C -40 ... +75 °C IP67 5-pin, M12 connector Plastic ABS Plastic 70 g ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ ◆ Date of issue: 10/4/01 Series 28 Ambient temperature Storage temperature Protection degree Connection type Housing Light exit Mass 0 ... 12 m 16 m (with H85 reflector) 50 ... 12000 mm Red, alternating light LED transmitter 1.2° receiver 2° approx. 200 mm at a distance of 12 m 80000 Lux EN 60947-5-2 CE UL CSA LED green 2 LEDs yellow, light up when light beam is free, flash when falling short of the stability control, off when light beam is interrupted rotary switch for light/dark sensitivity adjuster 10 ... 30 V DC 10 % £ 40 mA 2 pnp antivalent, short-circuit proof, protected against reverse polarity RL28-55/82b/105/110 Ordering code RL28-55/49/82b/105 RL28-55/82b/105/... RL28-55/47/82b/105 Technical Data Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com 2 RL28-55/82b/105/... Diagrams Characteristic response curve RL28-55; RLK28-55 Offset Y [mm] 180 160 140 120 100 80 60 40 20 0 0 5 10 15 H85 C110-2 H60 H160 F2000 y x 20 Distance X [m] RL28-55; RLK28-55 Relative received light strength Reflector type: H85 (80 mm x 80 mm) 50 mm C110_2 (ø = 84 mm) 50 mm H60 (60 mm x 40 mm) 50 mm F2000 (Foil, 100 mm x 100 mm) 50 mm H160 (60 mm x 18 mm) 50 mm 16 m 14 m 12 m 10 m 5m Stability control Stability control > 3 1000 Stability control < 3 H85 C110-2 H60 H160 F2000 100 10 3 x 1 5 10 15 20 Distance X [m] Date of issue: 10/4/01 Series 28 0 Subject to reasonable modifications due to technical advances. 3 Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com Dimensions and Electrical Connection RL28-55/82b/105/... Dimensions 2 5 3 Connector view 1 4 54.3 18.8 Print Type code Connection diagram SW 8 25.8 16 6 ø5.2 - 0.2 17.8 Receiver 9.8 10 2 4 11 5.2 - 0.2 25 88 62 Emitter M12 x 1 Dovetail mount 10 51.8 Sensitivity adjuster Light/dark switch LED indicator: switching state LED indicator: switching state LED indicator: operation Electrical Connection Option: 1 +UB 2 Q 3 0V 4 Q 5 I/O /47 /49 /110 /82b Q1 Q2 Date of issue: 10/4/01 Series 28 Alarm = Light ON, = Dark ON Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com 4