RG10 - RG10Y SUPER FAST RECTIFIER DIODES PRV : 70 - 600 Volts Io : 1.0 - 1.5 Amperes D2 FEATURES : * * * * * * High current capability High surge current capability High reliability Low reverse current Low forward voltage drop Super fast recovery time 1.00 (25.4) MIN. 0.161 (4.1) 0.154 (3.9) 0.284 (7.2) 0.268 (6.8) MECHANICAL DATA : 1.00 (25.4) MIN. 0.034 (0.86) 0.028 (0.71) * Case : D2 Molded plastic * Epoxy : UL94V-O rate flame retardant * Lead : Axial lead solderable per MIL-STD-202, Method 208 guaranteed * Polarity : Color band denotes cathode end * Mounting position : Any * Weight : 0.465 gram Dimensions in inches and ( millimeters ) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating at 25 ° C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. RATING SYMBOL RG10Y RG10 RG10A UNITS Maximum Recurrent Peak Reverse Voltage VRRM 70 400 600 Volts Maximum RMS Voltage VRMS 49 280 420 Volts Maximum Reverse Voltage VDC 70 400 600 Volts IF(AV) 1.5 1.2 1.0 Amp. Maximum Average Forward Current 0.375"(9.5mm) Lead Length Ta = 55 °C Peak Forward Surge Current, 8.3ms Single half sine wave Superimposed on rated load (JEDEC Method) IFSM 50 1.1 Amps. Maximum Peak Forward Voltage at IF = 1.0 A. VF 1.8 2.0 Volts Maximum DC Reverse Current Ta = 25 °C IR 5 µA at Rated DC Blocking Voltage Ta = 100 °C IR(H) 50 µA Maximum Reverse Recovery Time ( Note 1 ) Trr 35 ns Typical Junction Capacitance ( Note 2 ) CJ 50 pf Junction Temperature Range TJ - 65 to + 150 °C Storage Temperature Range TSTG - 65 to + 150 °C Notes : ( 1 ) Reverse Recovery Test Conditions : IF = 0.5 A, IR = 1.0 A, Irr = 0.25 A. ( 2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 VDC UPDATE : APRIL 23, 1998 RATING AND CHARACTERISTIC CURVES ( RG10 - RG10Y ) FIG.1 - REVERSE RECOVERY TIM E CHARACTERISTIC AND TEST CIRCUIT DIAGRAM Trr 10 Ω 50 Ω + 0.5 A D.U.T. 0 + PULSE GENERATOR ( NOTE 2 ) 50 Vdc (approx) 1Ω - 0.25 OSCILLOSCOPE ( NOTE 1 ) - 1.0 A SET TIME BASE FOR 15 ns/cm NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF. 1 cm 2. Rise time = 10 ns max., Source Impedance = 50 ohms. FIG.2 - DERATING CURVE FOR OUTPUT RECTIFIED CURRENT FIG.3 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 50 100 PEAK FORWARD SURGE CURRENT, AMPERES PERCENTAGE AGAINST RATED CURRENT Io (%) 3. All Resistors = Non-inductive Types. 80 60 40 20 8.3 ms SINGLE HALF SINE WAVE Ta = 50 °C 40 30 20 10 60Hz RESISTIVE OR INDUCTIVE LOAD 0 0 25 50 75 100 125 150 0 175 1 AMBIENT TEMPERATURE, ( ° C) FORWARD CURRENT, AMPERES 100 10 RG10 1.0 RG10A 0.1 Pulse Width = 300 µs 2% Duty Cycle 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 FORWARD VOLTAGE, VOLTS 6 10 20 40 60 100 2.2 10 TJ = 100 °C 1.0 0.1 TJ = 25 °C 0.01 0 20 40 60 80 100 120 PERCENT OF RATED REVERSE VOLTAGE, (%) TJ = 25 °C 0.01 0.4 4 FIG.5 - TYPICAL REVERSE CHARACTERISTICS REVERSE CURRENT, MICROAMPERES FIG.4 - TYPICAL FORWARD CHARACTERISTICS RG10Y 2 NUMBER OF CYCLES AT 60Hz 2.4 140