Optical disc ICs 4-channel BTL driver for CD players BA6397FP The BA6397FP is a 4-channel BTL driver for CD player motors and actuators. The 5V regulator and internal standard operational amplifier make this IC suited to a broad range of applications. Applications CD players and CD-ROM drives Features 1) HSOP 28-pin package allows for miniaturization of applications. 2) Low number of external components. 3) Driver gain is adjustable with a single attached resistor. Absolute maximum ratings (Ta = 25C) Recommended operating conditions (Ta = 25C) 332 4) Internal 5V regulator. (requires attached PNP transistor) 5) Internal standard operational amplifier. 6) Internal thermal shutdown circuit. Optical disc ICs BA6397FP Block diagram 333 Optical disc ICs Pin descriptions 334 BA6397FP Optical disc ICs BA6397FP Input / output circuits 335 Optical disc ICs BA6397FP Electrical characteristics (unless otherwise noted, Ta = 25C, VCC = 8V, f = 1kHz, RL = 8Ω) Circuit operation (1) Driver Inputs to the IC are the focus tracking error signal from the servo preamplifier and the control signal from the motor. The input signals, which normally center on 2.5V, are V / I converted by the preamplifier, generating a current corresponding to the input voltage. This current is 336 passed through a resistor and into the internal reference voltage component, the preamplifier output being a signal centering on the internal reference voltage. Two systems (positive phase and negative phase) are created during V / I conversion, generating BTL output via the driver buffer. Optical disc ICs BA6397FP (2) Regulator This is a typical series regulator that generates a reference voltage internally. A PNP low saturation type transistor must be connected. (3) Operational amplifier A standard 4558 type. Application example 337 Optical disc ICs Operation notes (1) The BA6397FP has an internal thermal shutdown circuit. Output current is muted when the chip temperature exceeds 175C (typically). (2) If the mute pin (pin 7) voltage is opened or lowered below 0.5V, the output current will be muted. Pin 7 should be pulled up above 2.0V during normal use. (3) The bias pin (pin 23) is muted when lowered below 1.4V (typically). Make sure it stays above 1.6V during normal use. (4) Muting occurs during thermal shutdown, mute-on operations or a drop in the bias pin voltage. In each case, only the drivers are muted. During muting, the output pins remain at the internal bias voltage, roughly (VCC–VF) / 2. Electrical characteristic curves 338 BA6397FP (5) The internal input resistor has a positive temperature coefficient of roughly 2000ppm / degree, and so when changing the gain using an attached resistor, gain will also change at a rate of roughly 2000ppm / degree. There is virtually no gain variation due to temperature when using the internal input resistor. (6) Be sure to connect the IC to a 0.1µF bypass capacitor to the power supply, at the base of the IC. (7) The radiating fin is connected to the package’s internal GND, but should also be connected to an external ground. (8) The capacitor between regulator output (pin 6) and GND also serves to prevent oscillation of the IC, so select one with good temperature characteristics. Optical disc ICs BA6397FP Electrical characteristic curves External dimensions (Units: mm) 339