KEMET C0201C103K4PAC

Product Bulletin
Surface Mount Ceramic Chip Capacitors – C0201 Series - X5R Dielectric
Outline Drawing
L
W
TIN PLATE
T
B
NICKEL PLATE
S
ELECTRODES
CONDUCTIVE METALLIZATION
Dimensions – Millimeters (Inches)
EIA Size Metric Size
Code
Code
0201
0603
L
Length
W
Width
B
Bandwidth
S
Separation
0.6 (.024) ± 0.03 (.001)
0.3 (.012) ± 0.03 (.001)
0.15 (.006) ± 0.05 (.002)
-
See Capacitance Value Table below for thickness dimension.
Capacitance Value
Capacitance
Value (uF)
KEMET Part Number
Voltage
0.01
C0201C103K4PAC
16
0.10
C0201C104K9PAC
6.3
Capacitance
Tolerance
Thickness
Qty
7" Reel
K,M
0.3 (.012) ± 0.03 (.001)
15,000
K,M
0.3 (.012) ± 0.03 (.001)
15,000
Capacitor Ordering Information
C 0201
C
104
K
9
P
A
C
End Metallization
C = Standard (Tin-plate
nickel barrier)
Style
C - Ceramic
Size Code
See dimension table
Failure Rate Level
A = Not Applicable
Specification
C - Standard
Capacitance Code, pF
First two digits represent significant figures.
Third digit specifies number of zeros. 100 pF = 101.
(Use “9” for 1.0 through 9.9 pF)
(Use “8” for 0.1 through .99 pF)
Capacitance Tolerance
K = ± 10%
M = ± 20%
F-9078C 08/06
Temperature Characteristic
Designated by Capacitance
Change Over Temperature Range
P = X5R (±15%) (-55°C +85°C)
Voltage
9 = 6.3V
4 = 16V
Electrical Parameters
As detailed in the KEMET Surface Mount Catalog F3102 for X5R, with following specific requirements
based on room temperature (25°C) parameters:
• Operating Range: -55°C to +85°C, with no-bias capacitance shift limited to ± 15% over that range.
• Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 500
megohm microfarads or 10000MΩ, whichever of the two is smaller.
• Capacitance and Dissipation Factor (DF) measured at 1 kHz and 1 Vrms. DF Limit is 10% max.**
** Please refer to individual specifications.
Soldering Process
These components are suitable for reflow only. All parts incorporate the standard KEMET
barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resistance to leaching.
Marking
These chips will be supplied unmarked.
In general, the information in the KEMET Surface Mount catalog F3102 applies to these
capacitors. The information in this bulletin supplements that in the catalog.
F-9078C 08/06
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com