Noise Suppression Products/EMI Suppression Filters > Chip Common Mode Choke Coils > Monolithic Type Data Sheet 1 Chip Common Mode Choke Coils Monolithic Type DLM2HG Series (1008 Size) ■ Dimension (5) 10000 (2) (4) Differential Mode 1000 Impedance (Ω) 0.3±0.2 (3) 2.5±0.2 (1) ■ Impedance-Frequency Characteristics (6) 100 Common Mode 2.0±0.2 1.2±0.2 10 1 1 0.4±0.2 0.8±0.1 10 (in mm) ■ Equivalent circuit 100 Frequency (MHz) 1000 10000 ■ Packaging (1) (2) (3) (4) (5) (6) Code Packaging Minimum Quantity L 180mm Embossed Tape 3000 B Bulk(Bag) 1000 No polarity. ■ Rated Value (p: packaging code) Part Number DLM2HGN601SZ3p Common Mode Impedance Rated Current Rated Voltage (at 100MHz/20°C) 600ohm±25% 100mA 16Vdc Insulation Resistance (min.) 100M ohm Withstand Voltage DC Resistance 100Vdc 0.40ohmmax. Operating Number of Circuit Temperature Range -40°C to 85°C 1 ■ !Caution/Notice !Caution (Rating) Do not use products beyond the rated current and rated voltage as this may create excessive heat and deteriorate the insulation resistance. Notice Solderability of Tin plating termination chip might be deteriorated when low temperature soldering profile where peak solder temperature is below the Tin melting point is used. Please confirm the solderability of Tin plating termination chip before use. o This data sheet is applied for CHIP COMMON MODE CHOKE COIL used for General Electronics equipment for your design. ! Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2006.3.9 http://www.murata.com/