HCC/HCF4517B DUAL 64-STAGE STATIC SHIFT REGISTER . . .. . .. .. CLOCK FREQUENCY 12MHz (TYP.) AT VDD = 10V SCHMITT TRIGGER CLOCK INPUTS ALLOW OPERATION WITH VERY SLOW CLOCK RISE AND FALL TIMES THREE-STATE OUTPUTS QUIESCENT CURRENT SPECIFIED AT 20V FOR HCC DEVICE STANDARDIZED, SYMMETRICAL OUTPUT CHARACTERISTICS 5V, 10V, AND 15V PARAMETRIC RATINGS INPUT CURREN OF 100nA AT 18V AND 25°C FOR HCC DEVICE 100% TESTED FOR QUIESCENT CURRENT MEETS ALL REQUIREMENTS OF JEDEC TENTATIVE STANDARD N°. 13A, ”STANDARD SPECIFICATIONS FOR DESCRIPTION OF ”B” SERIES CMOS DEVICES” EY (Plastic Package) F (Ceramic Package) C1 (Chip Carrier) ORDER CODES : HCC4517BF HCF4517BM1 HCF4517BC1 PIN CONNECTIONS DESCRIPTION The HCC4517B (extended temperature range) and HCF4517B (intermediate temperature range) are monolithic integrated circuits, available in 16-lead dual in-line plastic or ceramic package. The HCC/HCF4517B dual 64-stage static shift register consists of two independent registers each having a clock, data, and write enable input and outputs accessible at taps following the 16th, 32nd, 48th, and 64th stages. These taps also serve as input points allowing data to be inputted at the 17th, 33rd, and 49th stages when the write enable input is a logic 1 and the clock goes through a low-to-high transition. The truth table indicates how the clock and write enable inputs control the operation of the HCC/HCF4517B. Inputs at the intermediate taps allow entry of 64 bits into the register with 16 clock pulses. The 3-state outputs permit connection of this device to an external bus. September 1988 1/12 HCC/HCF4517B FUNCTIONAL DIAGRAM (one half) ABSOLUTE MAXIMUM RATINGS Symbol V DD* Parameter Supply Voltage : HC C Types H C F Types Value Unit – 0.5 to + 20 – 0.5 to + 18 V V Vi Input Voltage – 0.5 to V DD + 0.5 V II DC Input Current (any one input) ± 10 mA Total Power Dissipation (per package) Dissipation per Output Transistor for T o p = Full Package-temperature Range 200 mW 100 mW Pt ot Top Operating Temperature : HCC Types H CF Types – 55 to + 125 – 40 to + 85 °C °C Tstg Storage Temperature – 65 to + 150 °C Stresses above those listed under ”Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. * All voltages are with respect to VSS (GND). RECOMMENDED OPERATING CONDITIONS Symbol V DD VI T op 2/12 Parameter Supply Voltage : H CC Types H C F Types Input Voltage Operating Temperature : HC C Types H CF Types Value Unit 3 to 18 3 to 15 V V 0 to V DD V – 55 to + 125 – 40 to + 85 °C °C HCC/HCF4517B LOGIC DIAGRAM AND TRUTH TABLE Clock Write Enable D ata Stage 1 6 T ap Stage 3 2 Tap Stage 4 8 Ta p Stage 6 4 Ta p 0 0 X Q16 Q32 Q48 Q64 0 1 X Z Z Z Z 1 0 X Q16 Q32 Q48 Q64 1 1 X Z Z Z Z /– 0 DI In Q16 Q32 Q48 Q64 – –/ –\ – –\ – 1 Di In D17 In D33 In D49 In Z 0 X Q16 Q32 Q48 Q64 1 X Z Z Z Z – 3/12 HCC/HCF4517B STATIC ELECTRICAL CHARACTERISTICS (over recommended operating conditions) Symbol IL Parameter Quiescent Current HCC Types HCF Types V OH V OL V IH V IL I OH Output High Voltage Output Low Voltage Input High Voltage Input Low Voltage Output Drive Current HCC Types HCF Types IOL Output Sink Current HCC Types HCF Types I IH, I IL I O H, I OL CI Input Leakage Current HCC Types HCF Types 3-State HCC Output Types Leakage HCF Current Types Input Capacitance Test Conditions VO |I O | V D D T L o w* (V) (µA) (V) Min. Max. 0/ 5 5 5 0/10 10 10 0/15 15 20 0/20 20 100 0/ 5 5 20 0/10 10 40 0/15 15 80 0/ 5 < 1 5 4.95 0/10 < 1 10 9.95 0/15 < 1 15 14.95 5/0 < 1 5 0.05 10/0 < 1 10 0.05 15/0 < 1 15 0.05 0.5/4.5 < 1 5 3.5 1/9 < 1 10 7 1.5/13.5 < 1 15 11 4.5/0.5 < 1 5 1.5 9/1 < 1 10 3 13.5/1.5 < 1 15 4 0/ 5 2.5 5 –2 0/ 5 4.6 5 – 0.64 0/10 9.5 10 – 1.6 0/15 13.5 15 – 4.2 0/ 5 2.5 5 – 1.53 0/ 5 4.6 5 – 0.52 0/10 9.5 10 – 1.3 0/15 13.5 15 – 3.6 0/ 5 0.4 5 0.64 0/10 0.5 10 1.6 0/15 1.5 15 4.2 0/ 5 0.4 5 0.52 0/10 0.5 10 1.3 0/15 1.5 15 3.6 Value 25 °C Min. Typ. Max. 0.04 5 0.04 10 0.04 20 0.08 100 0.04 20 0.04 40 0.04 80 4.95 9.95 14.95 0.05 0.05 0.05 3.5 7 11 1.5 3 4 – 1.6 – 3.2 – 0.51 – 1 – 1.3 – 2.6 – 3.4 – 6.8 – 1.36 – 3.2 – 0.44 – 1 – 1.1 – 2.6 – 3.0 – 6.8 0.51 1 1.3 2.6 3.4 6.8 0.44 1 1.1 2.6 3.0 6.8 18 ± 0.1 ±10– 5 ± 0.1 0/15 15 ± 0.3 ±10 ± 0.3 ±1 0/18 18 ± 0.4 ±10– 4 ± 0.4 ± 12 0/18 15 ± 1.0 ±10– 4 ± 1.0 ± 7.5 VI (V) 0/18 T Hi g h * Min. Max. 150 300 600 3000 150 300 600 4.95 9.95 14.95 0.05 0.05 0.05 3.5 7 11 1.5 3 4 – 1.15 – 0.36 – 0.9 – 2.4 – 1.1 – 0.36 – 0.9 – 2.4 0.36 0.9 2.4 0.36 0.9 2.4 µA V V V V mA mA ±1 µA Any Input Any Input Unit 5 –5 7.5 µA pF * TLo w = – 55°C for HCC device : – 40°C for HCF device. * THigh = + 125°C for HCC device : + 85°C for HCF device. The Noise Margin for both ”1” and ”0” level is : 1V min. with VDD = 5V, 2V min. with VDD = 10V, 2.5V min. with VDD = 15V, 4/12 HCC/HCF4517B DYNAMIC ELECTRICAL CHARACTERISTICS (T amb = 25°C, Input t r, tf = 20ns, C L = 50pF, R L = 200kΩ) Symbol Parameter t P HL , t P L H Propagation Delay Time : CL to Bit 16 Tap t PL Z , t P HZ 3-State Output WE to Bit 16 Tap t PZ L , t P ZH (see note) t THL , t T L H Output Transition Time Test Conditions Value V D D (V) Min. Typ. Max. 5 200 400 10 110 220 15 90 180 5 75 150 10 40 80 15 30 60 5 100 200 10 50 100 40 80 15 t se t u p t se t u p Write Enable to Clock Data to Clock Write Enable to Clock Release Time t h o ld tW Data to Clock Minimum Clock Pulse Width 5 – 100 – 50 10 – 50 – 25 15 – 30 – 15 5 – 100 – 50 10 – 60 – 30 15 – 30 – 15 t f , tr Maximum Clock Input Frequency 50 100 25 50 15 20 40 5 100 200 10 50 100 15 25 50 5 90 180 10 40 80 25 50 Maximum Clock Input Rise or Fall Time 3 6 10 6 12 15 8 15 ns ns ns 5 5 ns ns 10 15 f CL Unit ns ns ns MHz 5 10 UNLIMITED µs 15 Note : Measured at the point of 10% change in output load of 50pF, RL = 1kΩ to VDD for t PZL, tPLZ and RL = 1kΩ to VSS for tPHZ. 5/12 HCC/HCF4517B WAVEFORMS Output Low (sink) Current Characteristics. Output High (source) Current Characteristics. Typical Transition Time vs. Load Capacitance. Typical Propagation Delay Time vs. Load Capacitance. 6/12 HCC/HCF4517B Typical Dynamic Power Dissipation vs. Frequency. Dynamic Power Dissipation and Waveforms. TEST CIRCUITS 7/12 HCC/HCF4517B TEST CIRCUITS (continued) 8/12 HCC/HCF4517B Plastic DIP16 (0.25) MECHANICAL DATA mm DIM. MIN. a1 0.51 B 0.77 TYP. inch MAX. MIN. TYP. MAX. 0.020 1.65 0.030 0.065 b 0.5 0.020 b1 0.25 0.010 D 20 0.787 E 8.5 0.335 e 2.54 0.100 e3 17.78 0.700 F 7.1 0.280 I 5.1 0.201 L Z 3.3 0.130 1.27 0.050 P001C 9/12 HCC/HCF4517B Ceramic DIP16/1 MECHANICAL DATA mm DIM. MIN. TYP. inch MAX. MIN. TYP. MAX. A 20 0.787 B 7 0.276 D E 3.3 0.130 0.38 e3 0.015 17.78 0.700 F 2.29 2.79 0.090 0.110 G 0.4 0.55 0.016 0.022 H 1.17 1.52 0.046 0.060 L 0.22 0.31 0.009 0.012 M 0.51 1.27 0.020 0.050 N P Q 10.3 7.8 8.05 5.08 0.406 0.307 0.317 0.200 P053D 10/12 HCC/HCF4517B PLCC20 MECHANICAL DATA mm DIM. MIN. TYP. inch MAX. MIN. TYP. MAX. A 9.78 10.03 0.385 0.395 B 8.89 9.04 0.350 0.356 D 4.2 4.57 0.165 0.180 d1 2.54 0.100 d2 0.56 0.022 E 7.37 8.38 0.290 0.330 e 1.27 0.050 e3 5.08 0.200 F 0.38 0.015 G 0.101 0.004 M 1.27 0.050 M1 1.14 0.045 P027A 11/12 HCC/HCF4517B Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsability for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may results from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use ascritical components in life support devices or systems without express written approval of SGS-THOMSON Microelectonics. 1994 SGS-THOMSON Microelectronics - All Rights Reserved SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A 12/12