IDT ICS9120-45

Integrated
Circuit
Systems, Inc.
ICS9120-45
Low-Cost 8-Pin Frequency Generator
General Description
Features
The ICS9120-45 is a high performance frequency generator
designed to support the clock requirements of communication
and audio interfaces.
•
•
•
•
•
•
•
•
High accuracy, low-jitter PLLs meet the -96dB signal-tonoise ratios required by 16-bit audio systems. Fast output
clock edge rates minimize board induced jitter.
The on-chip XTAL oscillator accuracy is better than ±100ppm
for an AT cut, 18pF load crystal with initial accuracy of ppm
plus TC, aging and load variation of ±20ppm each assuming
33pF ±5% external load capacitors.
Generates 32MHz, 40MHz and 48MHz
Single 10 MHz crystal reference
49.92 MHz accuracy tracks 40.32 MHz reference
80ps one sigma jitter maintains 16-bit performance
Output rise/fall times less than 1.5ns
On-chip loop filter components
3.0-5.5V supply range
8-pin, 150-mil SOIC package
Pin Configuration
Block Diagram
8 Pin SOIC
This data sheet (ICS9120-45) is an addedum to the existing ICS9120-08/09
data sheet. All information in this data sheet supersedes the data found in the
orginal ICS9120-08/09 data sheet.
9120-45 Rev B 05/23/97
ICS reserves the right to make changes in the device data identified in this
publication without further notice. ICS advises its customers to obtain the latest
version of all device data to verify that any information being relied upon by the
customer is current and accurate.
ICS9120-45
Pin Descriptions
PIN
NUMBER
1
2
3
4
5
6
7
8
PIN NAME
X1
VDD
40.00
50.00
48.00
GND
32.00
X2
MHz
MHz
MHz
MHz
TYPE
DESCRIPTION
Input
Power
Output
Output
Output
Power
Output
Output
10.00 MHz input from crystal.
+Power supply input.
40 MHz clock output.
50 MHz clock output.
48 MHz clock output.
Ground return for Pin 2.
32 MHz clock output.
10.00 MHz output.
Note: The 10.00 MHz crystal that is connected to pin 1 and 8 is a parallel resonant component
that is designed to operate into a 8pF capacitive load. This device is a 5V power supply device.
2
ICS9120-45
Absolute Maximum Ratings
AVDD,VDD referenced to GND . . . . . . . . . . . . . . . . 7V
Operating temperature under bias. . . . . . . . . . . . . . . . 0°C to +70°C
Storage temperature . . . . . . . . . . . . . . . . . . . . . . . . . . -65°C to +150°C
Voltage on I/O pins referenced to GND. . . . . . . . . . . GND -0.5V to VDD +0.5V
Power dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 Watts
Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress
rating only and functional operation of the device at these or any other conditions above those indicated in the operational
sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may
affect product reliability.
Electrical Characteristics at 5 V
VDD = +4.5 to +5.5 V, TA = 0-70oC unless otherwise stated
DC Characteristics
PARAMETER
Input Low Voltage
Input High Voltage
Input Low Current
Input High Current
Output Low Voltage
Output High Voltage
Output Low Current
Output High Current
Supply Current
Supply Current
Pull-up Resistor Value
SYMBOL
VIL
VIH
IIL
IIH
VOL*
VOH*
IOL*
I OH*
ICC
ICC
Rpu*
Rise Time 0.8 to 2.0V
Fall Time 2.0 to 0.8V
Rise Time 20% to 80%
Fall Time 80% to 20%
Duty Cycle
Tr*
Tf*
Tr*
Tf*
Dt*
Duty Cycle
Dt*
Jitter, One Sigma
Tjis*
Jitter, Absolute
Tjab
TEST CONDITIONS
VIN=0V (For -09 only)
VIN=VDD (For -09 only)
IOL=+10mA
IOH=-30mA
VOL=0.8V
VOH=2.4V
Unloaded
Unloaded (For -09 only)
(For -09 only)
MIN
2.0
2.4
25.0
-
TYP
-8.3
0.15
3.7
45.0
-53.0
22.0
180.0
400.0
MAX
0.8
-18.0
5.0
0.4
-35.0
50.0
500.0
800.0
UNITS
V
V
µA
µA
V
V
mA
mA
mA
µA
k ohm
-
0.9
0.7
1.8
1.4
2.0
1.5
3.25
2.5
ns
ns
ns
ns
45.0
50.0
55.0
%
40.0
50.0
60.0
%
-
85.0
-
ps
-700.0
380.0
700.0
ps
-1.5
11.0
11.0
-
266.0
380.0
14.0
5.5
5
600.0
1.5
17.0
42.0
12.0
-
ps
ns
MHz
MHz
ms
pF
AC Characteristics
Jitter, One Sigma
Jitter, Absolute
Input Frequency
Output Frequency
Power-up Time
Crystal Input Capacitance
Tjis*
Tjab
Fi*
Fo *
Tpu*
Cinx*
15pF load
15pF load
15pF load
15pF load
15pF load @ 50% of VDD;
Except REFCLK
15pf load @ 50% of VDD;
REFCLK only
For all frequencies except
REFCLK
For all frequencies except
REFCLK
REFCLK only
REFCLK only
0 to 33.8 MHz
X1 (Pin 1)# X2 (Pin 8; -08 only)
* Parameter is guaranteed by design and characterization. Not 100% tested in production.
3
ICS9120-45
Electrical Characteristics at 3.3 V
DC Characteristics
PARAMETER
Input Low Voltage
Input High Voltage
Input Low Current
Input High Current
Output Low Voltage
Output High Voltage
Output Low Current
Output High Current
Supply Current
Supply Current
Pull-up Resistor Value
SYMBOL
VIL
Rise Time 0.8 to 2.0V
Fall Time 2.0 to 0.8V
Rise Time 20% to 80%
Fall Time 80% to 20%
Tr*
Tf*
Tr*
Tf*
Duty Cycle
Dt*
Duty Cycle
Dt*
Jitter, One Sigma
Tjis*
Jitter, Absolute
Tjab
Jitter, One Sigma
Jitter, Absolute
Input Frequency
Output Frequency
Power-up Time
Crystal Input Capacitance
Tjis*
Tjab
Fi*
Fo*
Tpu*
Cinx*
VIH
IIL
IIH
VOL*
VOH*
IOL*
IOH*
ICC
ICC(PD)
Rpu*
TEST CONDITIONS
VIN=0V (For -09 only)
VIN=VDD (For -09 only)
IOL=6mA
IOH=-4.0mA
VOL=0.2VDD
VOH=0.7VDD
Unloaded
Unloaded (For -09 only)
(For -09 only)
MIN
0.7VDD
0.85VDD
15.0
-
TYP
-3.6
0.05VDD
0.94VDD
24.0
-13.0
13.0
50.0
620.0
MAX
0.2VDD
-8.0
5.0
0.1
-8.0
32.0
110.0
900.0
UNITS
V
V
µA
µA
V
V
mA
mA
mA
µA
k ohm
-
1.5
1.0
2.2
1.5
4.0
3.0
4.0
3.0
ns
ns
ns
ns
45.0
50.0
55.0
%
40.0
45.0
60.0
%
-
100.0
-
ps
-900.0
380.0
900.0
ps
-1.5
11.0
11.0
266.0
380.0
14.3
-
600.0
1.5
15.0
38.0
ps
ns
MHz
MHz
-
5
-
pF
AC Characteristics
15pF load
15pF load
15pF load
15pF load
15pF load @ 50% of VDD;
Except REFCLK
15pF load @ 50% of VDD;
REFCLK only
For all frequencies except
REFCLK
For all frequencies except
REFCLK
REFCLK only
REFCLK only
0 to 33.8 MHz - 5.5 12.0 ms
X1 (Pin 1)# X2 (Pin 8; -08 only)
* Parameter is guaranteed by design and characterization. Not 100% tested in production.
4
ICS9120-45
0.154
0.031
0.194
0.063
0.015
0.024
0.008
0.025
0.016
0.238
0.050 0.006
± 0.004
8-Pin SOIC Package
Ordering Information
ICS9120M-45
Example:
ICS XXXX M-PPP
Pattern Number (2 or 3-digit number for parts with ROM code pattern)
Package Type
M =SOIC
Device Type (consists of 3 or 4-digit numbers)
Prefix
ICS, AV=Standard Device
5
ICS reserves the right to make changes in the device data identified in this
publication without further notice. ICS advises its customers to obtain the latest
version of all device data to verify that any information being relied upon by the
customer is current and accurate.