PGR 203 02 PIN Receiver Module up to 3 Gb/s Key Features • Hermetic, 14 pin butterfly package with multisourced footprint • FC/PC, SC or ST connector • InGaAs PIN photo diode with low noise GaAs MMIC preamplifier • AC-coupled, differential data output • Operates between 1250 nm and 1620 nm • 2.0 GHz minimum bandwidth • -25 dBm typical sensitivity • +0.5 dBm typical overload Applications • WDM • SDH STM-16 SH • SONET OC-48 IR • Digital recievers to 3 Gb/s • Analog receivers to 2.0 GHz Description Fiber optic receiver front-end module for STM-16 and OC-48 WDM applications. The module includes an InGaAs PIN Photo Diode, with a low noise GaAs MMIC preamplifier in a 14 pin butterfly package. The single-mode fiber pigtail is terminated with a customer specified connector. The module operates between 1250 and 1620 nm. The electrical outputs are AC-coupled and differential. 1 PGR 203 02 FIBER DATA PIN PREAMP DATA_NOT Figure 1. Block diagram Pin connection GND Data Out (AC-coupled) Data_Not Out (AC-coupled) GND Vdd (+5V) NC RF (and DC) GND 2.54 A Lead 1 1.1 12.7 2°- 8° ø 2.7 4x M3 depth min 2.54 2.6 Lead 14 12.7 2.5 A 17.9 19.2+0 -0.55 25.4 Figure 2. Pin description 2 20.2 8 4.5 20.5 ±0.3 1.3 9. 10. 11. 12. 13. 14. Case 0.25 GND Vpin (+5V) GND Vss (-5.2V) GND NC GND GND 3.9 1. 2. 3. 4. 5. 6. 7. 8. PGR 203 02 Optical and Electrical AC Characteristics Electrical and optical characteristics over recommended operating conditions, unless otherwise noted. Parameters are met by an individual differential output. Parameter Conditions Symbol Min Typ Max Minimum bandwidth (-3dB) Bandwidth variation -20dBm < Pf < -3dBm -20dBm < Pf < -3dBm BWmax = α·BWmin BWmin α 2.0 2.5 1.1 1.2 0 -25 2 -22 Gain peaking Sensitivity: Pf @ BER = 1·10-10 Overload: Pf @ BER = 1·10-10 Output signal swing AC transimpedance Logic sense 2.5 Gbps NRZ, PRBS 223-1, λ =1550 nm 2.5 Gbps NRZ, PRBS 223-1, λ =1550 nm -20dBm < Pf < -3dBm RL = 50Ω, λ = 1550nm, ER ~10 RL = 50Ω, Tz = dVOut/lPh, ave Data out Data_Not Out δPeak Pr Unit GHz 0.5 dB dBm Pol 0 dBm VOut 25 Tz 3.0 kΩ Light "ON" = Logic "LOW" Light "ON" = Logic "HIGH" 800 mVP-P Optical and Electrical DC Characteristics Electrical and optical characteristics over recommended operating conditions, unless otherwise noted. Parameters are met by an individual differential output. Parameter Conditions DC Power supply current Power consumption PIN Responsivity λ = 1300 nm λ = 1550 nm Optical reflectance Symbol Min Idd Iss PCon R13 R15 s11 Typ Max Unit 110 55 0.8 0.9 1.0 140 70 1.1 -27 mA mA W A/W A/W dB Max Unit 1620 85 5.3 -4.9 nm °C V V V Recommended Operating Conditions Parameter Symbol Min Typ λ TCase Vdd Vss VPin 1250 -40 4.7 -5.5 Parameter Symbol Min Max Unit DC Power supply voltage Vdd Vss TStg -0.5 -7.0 -40 6.5 0.5 85 V V °C Optical wavelength Case temperature DC Power supply voltage PIN bias 5.0 -5.2 5 Absolute Maximum Ratings Storage temperature CAUTION: Stresses outside those listed in ”Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. 3 PGR 203 02 Handling Precautions This device may be damaged as a result of electrostatic discharge (ESD). Take proper precautions during both handling and testing. This typically includes grounded wrist wraps, workbenches and floor mats in ESD controlled areas. Semiconductor devices may be damaged by current surges, use appropriate transient protection. Quality Assurance Ericsson Microelectronics commitment to quality has been proven through a decade of semiconductor device production and has been confirmed to ISO 9001. Opto product qualification is made according to the intention of applicable Telcordia standards. Connector Options FC/PC SC ST (Other connectors available on request) Information given in this data sheet is believed to be accurate and reliable. However no responsibility is assumed for the consequences of its use nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Ericsson Microelectronics. These products are sold only according to Ericsson Microelectronics' general conditions of sale, unless otherwise confirmed in writing. Product specifications subject to change without notice. Ericsson Microelectronics AB SE-164 81 Kista, Sweden Telephone: +46 8 757 50 00 www.ericsson.com/microelectronics For local sales contacts, please refer to our website or call: Int + 46 8 757 47 00, Fax: +46 8 757 47 76 4 1522-PGR 203 02 Rev. C © Ericsson Microelectronics AB, August 2000