PLL PLL500

PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
FEATURES
•
•
VCXO output for the 17MHz to 36MHz range
Low phase noise (-130 dBc @ 10kHz offset at
35.328MHz).
CMOS output with OE tri-state control.
17 to 36MHz fundamental crystal input.
Integrated high linearity variable capacitors.
12mA drive capability at TTL output.
+/- 150 ppm pull range, max 5% (typ.) linearity.
Low jitter (RMS): 2.5ps period jitter.
2.5 to 3.3V operation.
Available in 8-Pin SOIC, 6-pin SOT23 GREEN/
RoHS compliant packages, or DIE.
XIN
1
VDD*
2
VCON
3
GND
4
PLL500-17
•
•
•
•
•
•
•
•
PIN CONFIGURATION
8
XOUT
7
OE^
6
VDD*
5
CLK
SOIC-8
1
GND
2
CLK
3
P500-17
DESCRIPTION
XOUT
6
XIN
5
VDD
4
VCON
SOT23-6
The PLL500-17 is a low cost, high performance and
low phase noise VCXO for the 17 to 36MHz range,
providing less than -130dBc at 10kHz offset at
35.328MHz. The very low jitter (2.5 ps RMS period
jitter) makes this chip ideal for applications requiring
voltage controlled frequency sources. Input crystal
can range from 17 to 36MHz (fundamental resonant
mode).
^: Denotes internal Pull-up
*: Only one VDD pin needs to be connected
BLOCK DIAGRAM
XIN
XOUT
XTAL
OSC
VARICAP
CLK
OE
VCON
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 1
PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
DIE PAD LAYOUT
32 mil
(812,986)
DIE SPECIFICATIONS
8
1
XOUT
XIN
OE^ 7
39 mil
2
VDD
VDD 6
3 VCON
Name
Value
Size
Reverse side
Pad dimensions
Thickness
39 x 32 mil
GND
80 micron x 80 micron
10 mil
CLK 5
4 GND
DIE ID: PLL500-17: C500A0404-04A
Y
(0,0)
X
Note: ^ denotes internal pull up
PACKAGE PIN and DIE PAD ASSIGNMENT
Pin#
Name
Die Pad Position
Type
Description
SOP-8
SOT23-6
X (µm)
Y (µm)
XIN
1
6
94.183
768.599
I
Crystal input pin.
VDD
2
5
94.157
605.029
P
VDD power supply pin. Only one VDD pin is necessary.
VCON
3
4
94.183
331.756
I
Frequency control voltage input pin.
GND
4
2
94.193
140.379
P
Ground pin.
CLK
5
3
715.472
203.866
O
Output clock pin.
VDD
6
-
715.307
455.726
P
VDD power supply pin. Only one VDD pin is necessary.
OE
7
-
715.472
626.716
I
Output Enable input pin. Disables the output when
low. Internal pull-up enables output by default if
pin is not connected to low.
XOUT
8
1
476.906
888.881
I
Crystal output pin. Ref Clock input.
* OE (Output Enable) pin is not available in SOT-26 package, the output will always be enabled by the build in pull-up resister.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 2
PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS
SYMBOL
Supply Voltage
MIN.
V DD
MAX.
UNITS
4.6
V
Input Voltage, dc
VI
-0.5
V DD +0.5
V
Output Voltage, dc
VO
-0.5
V DD +0.5
V
Storage Temperature
TS
-65
150
°C
Ambient Operating Temperature*
TA
-40
85
°C
Junction Temperature
TJ
125
°C
Lead Temperature (soldering, 10s)
260
°C
ESD Protection, Human Body Model
2
kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other
conditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
2. AC Electrical Specifications
PARAMETERS
SYMBOL
CONDITIONS
Input Crystal Frequency
MIN.
TYP.
17
Output Clock Rise/Fall Time
Output Clock Duty Cycle
0.8V ~ 2.0V with 10 pF load
1.15
0.3V ~ 3.0V with 15 pF load
3.7
Measured @ 1.4V
45
50
MAX.
UNITS
36
MHz
ns
55
±50
Short Circuit Current
%
mA
3. Voltage Control Crystal Oscillator
PARAMETERS
VCXO Stabilization Time *
SYMBOL
T VCXOSTB
VCXO Tuning Range
CLK output pullability
VCXO Tuning Characteristic
Pull range linearity
Power Supply Rejection
VCON pin input impedance
VCON modulation BW
PWSRR
CONDITIONS
From power valid
XTAL C 0 /C 1 < 250
0V ≤ VCON ≤ 3.3V
VCON=1.65V, ±1.65V
Frequency change with
VDD varied +/- 10%
0V ≤ VCON ≤ 3.3V, -3dB
MIN.
TYP.
MAX.
UNITS
10
ms
300
ppm
100
5
10
ppm
ppm/V
%
+1
ppm
±150
-1
2000
45
kΩ
kHz
Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 3
PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
4. Jitter and Phase Noise Specifications
PARAMETERS
CONDITIONS
MIN.
TYP.
MAX.
UNITS
RMS Period Jitter
(1 sigma – 1000 samples)
With capacitive decoupling between
VDD and GND.
2.5
ps
Phase Noise relative to carrier
36MHz @100Hz offset
-80
dBc/Hz
Phase Noise relative to carrier
36MHz @1kHz offset
-110
dBc/Hz
Phase Noise relative to carrier
36MHz @10kHz offset
-130
dBc/Hz
Phase Noise relative to carrier
36MHz @100kHz offset
-138
dBc/Hz
Phase Noise relative to carrier
36MHz @1MHz offset
-145
dBc/Hz
5. DC Specifications
PARAMETERS
Supply Current, Dynamic,
with Loaded Outputs
Operating Voltage
Output Low Voltage at
CMOS level
Output High Voltage at
CMOS level
Output drive current
Short Circuit Current
VCXO Control Voltage
SYMBOL
I DD
CONDITIONS
MIN.
F XIN = 36MHz
Output load of 15pF
V DD
TYP.
MAX.
UNITS
5
6
mA
3.63
V
0.4
V
2.25
V OLC
I OL = +4mA
V OHC
I OH = -4mA
V DD – 0.4
For V OL <0.4V or V OH >2.4V
8
V
9.5
V DD
mA
mA
V
MAX.
UNITS
36
MHz
pF
200
µW
µW
pF
-
±50
VCON
0
6. Crystal Specifications
PARAMETERS
Crystal Resonator Frequency
Crystal Loading Rating (VCON = 1.65V)
Maximum Sustainable Drive Level
Operating Drive Level
C0
C0/C1
ESR
SYMBOL
MIN.
F XIN
C L (xtal)
17
TYP.
8.5
50
RS
5
250
30
Ω
Note: The crystal must be such that it oscillates (parallel resonant) at nominal frequency when presented a C Load as specified above.
If the crystal requires more load to be at nominal frequency, the additional load must be added externally.
This however may reduce the pull range.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 4
PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
PACKAGE INFORMATION (GREEN PACKAGE COMPLIANT)
SOIC 8L
Symbol
A
A1
A2
B
C
D
E
H
L
e
Dimension in MM
Min.
Max.
1.35
1.75
0.10
0.25
1.25
1.50
0.33
0.53
0.19
0.27
4.80
5.00
3.80
4.00
5.80
6.20
0.40
0.89
1.27 BSC
E
H
D
A2 A
A1
C
L
b
e
SOT23-6 L
Symbol
A
A1
A2
b
c
D
E
H
L
e
Dimension in MM
Min.
Max.
1.05
1.35
0.05
0.15
1.00
1.20
0.30
0.50
0.08
0.20
2.80
3.00
1.50
1.70
2.60
3.0
0.35
0.55
0.95 BSC
Pin1 Dot
E
H
D
A2 A
A1
C
e
b
L
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 5
PLL500-17
Low Phase Noise VCXO (17MHz to 36MHz)
ORDERING INFORMATION (GREEN PACKAGE)
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PLL502-51 X C X R
NONE= TUBE
R=TAPE AND REEL
PART NUMBER
NONE=NORMAL PACKAGE
L=GREEN PACKAGE
PACKAGE TYPE
D=Die
S= SOIC
T= SOT
TEMPERATURE
C=COMMERCIAL
I=INDUSTRIAL
Part / Order Number
Marking
PLL500-17DC
P500-17DC
P500-17SC
P500-17SC
P500-17SCL
P500-17SCL
P500-17TC
P500-17TCL
PLL500-17SC
PLL500-17SC-R
PLL500-17SCL
PLL500-17SCL-R
PLL500-17TC-R
PLL500-17TCL-R
Package Option
Die (Waffle Pack)
8-Pin SOIC (Tube)
8-Pin SOIC (Tape and Reel)
8-Pin SOIC GREEN (Tube)
8-Pin SOIC GREEN (Tape and Reel)
6-Pin SOT (Tape and Reel)
6-Pin SOT GREEN (Tape and Reel)
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/08/06 Page 6