TOCOS ® RV30 Series PA N E L C O N T R O L S 30mm Diameter, Single-Turn, Carbon Industrial Panel Controls RV30YN RV30YD RV30YNME Features 30mm diameter, single-turn industrial panel controls Carbon film element Linear or audio tapers Single, tandem and triple units, single shaft; dual unit, dual shaft SPST or SPDT switch with 1A or 3A rating Shaft lock models Metal shaft and bushing Panel mount only Right angle ear-lug terminals 6mm diameter shafts in slot, flat or round end styles Standard 15mm or 20mm shaft length Specifications Electrical Environmental Standard Resistance Range . . . . . . . . . . B = 100Ω to 2MΩ A,C = 1kΩ to 2MΩ Resistance Tolerance . . . . . . . . . . . . . . . . . 10% standard End Resistance . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Ω max. Resistance Taper . . . . B = linear; A = CW audio (logarithm); C = CCW audio (logarithm) Peak Noise (C.R.V.) . . . . . . . 3% or 3Ω, whichever is greater Power Rating . . . . Ratings below at 40C, 0 watt at 85C Temperature Range . . . . . . . . . . . . . . . . . . 10C to 85C Taper B A,C R ) 10kΩ 1.0W 0.8W 10kΩ ! R ) 50kΩ 0.8W 0.6W 50kΩ ! R ) 300kΩ 0.6W 0.3W R 1 300kΩ 0.4W 0.2W Temperature Characteristics . . . . . . . . 85C, 30 minutes without load R ) 10kΩ ➞ ∆T/R )6% 10kΩ ! R ! 1MΩ ➞ ∆T/R )10% R 0 1MΩ ➞ ∆T/R )15% Load Life . . . . . . . . . . . . 40C, 1,000 hours with rated load ∆T/R )10% Moisture and Load Life . . . . . . . . . . . . 40C, 90-95%RH, 500 hours with rated load R ! 100kΩ ➞ ∆T/R )10%~15% R 0 100kΩ ➞ ∆T/R )10%~20% Maximum Input Voltage . . . . . B = 500VDC; A,C = 350VDC or power rating, whichever is smaller Insulation Resistance . . . . . 100MΩ minimum at 1,000VDC Dielectric Strength . . . . . . . . . . . . . . . . 1,000VAC, 1 minute Adjustment Travel . . . . . . . . . . . . . . . . . . . . . . . . . 28010 Thermal Shock . . . . . . . . . . . . . . . . . . . . . . . 10C ~85C, 5 cycles without load ∆T/R )10% Mechanical Soldering Heat Resistance . . . . . . . . . . 350C, 3.5 seconds ∆T/R )2% Mechanical Travel . . . . . . . . . . . . . . . . . . . . . . . . . . 3005 Shaft Torque Single Unit . . . . . . 51 to 306 gf • cm (0.707 to 4.242 oz • in) Other Units . . . . . . 51 to 510 gf • cm (0.707 to 7.070 oz • in) Stop Strength . . . . . . . . . . . . 10.2 kgf • cm (141.4 oz • in) max. Mounting Nut Torque . . . . . . 15 kgf • cm (207.94 oz • in) max. Solderability . . . . . . . . . . . . . . . . . . . . . . . 235C, 5 seconds Marking . . . . . . . . . . . . . Model type, taper, resistance code, shaft type, terminal identification, date code Vibration . . . . . . . . . . . . . . . . . . .10-55Hz, 1.5mm amplitude, 3 directions, 2 hours each ∆T/R )2.5% Rotational Life . . . . 15,000 cycles (500 cycles for shaft lock models only) without load ∆T/R )7% Standard Rotary Switches Switch Rating . . . . . . . . . . 110VAC, 1A or 3A, SPDT or SPST Contact Resistance . . . . . . . . . . . . . . . . . . . . . . 0.05Ω max. Operating Torque . . . . . . . . 1,530 gf • cm (21.21 oz • in) max. Operating Life . . . . . . . . . . . . . 10,000 cycles with rated load R = Total Resistance Value; ∆T/R = Total Resistance Change TOCOS AMERICA, INC. 44 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com RV30 Series Dimensions RV30YN Unit: mm Panel Mount, Single Unit, Single Shaft, Right Angle Ear-Lug Terminals RV30YNHT High Torque or RV30YS Panel Seal Models available as Special Order. Recommended Panel Mounting Holes RV30YL Panel Mount, Single Unit, Single Shaft with Shaft Lock Right Angle Ear-Lug Terminals Recommended Panel Mounting Holes RV30YNSE & RV30YNSF Panel Mount, Single Unit with Switch, Single Shaft Right Angle Ear-Lug Terminals, Rear Exit Lug Terminals for 1A or 3A SPST Switch Recommended Panel Mounting Holes TOCOS AMERICA, INC. 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 45 E-mail: [email protected] www.tocos.com RV30 Series Dimensions RV30YNME & RV30YNMF Unit: mm Panel Mount, Single Unit with Switch, Single Shaft Right Angle Ear-Lug Terminals, Rear Exit Lug Terminals for 1A or 3A SPDT Switch Recommended Panel Mounting Holes RV30YG Panel Mount, Ganged Tandem Unit, Single Shaft Right Angle Ear-Lug Terminals on Each Unit Recommended Panel Mounting Holes RV30YGL Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft Lock Right Angle Ear-Lug Terminals on Each Unit Recommended Panel Mounting Holes TOCOS AMERICA, INC. 46 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com RV30 Series Dimensions RV30YGSE, RV30YGSF, RV30YGME & RV30YGMF Unit: mm Panel Mount, Ganged Tandem Unit with Switch, Single Shaft Right Angle Ear-Lug Terminals on Each Unit Rear Exit Lug Terminals for 1A or 3A SPST or SPDT Switch Recommended Panel Mounting Holes RV30YT Panel Mount, Triple Unit, Single Shaft Right Angle Ear-Lug Terminals on Each Unit Recommended Panel Mounting Holes RV30YD Panel Mount, Dual Unit, Dual Concentric Shaft Right Angle Ear-Lug Terminals on Each Unit Recommended Panel Mounting Holes TOCOS AMERICA, INC. 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 47 E-mail: [email protected] www.tocos.com RV30 Series Part Numbering System RV 30 Y N ME 20 S B 103 K NOTE: FMS = From Mounting Surface Resistance Tolerance: K = 10% (standard). Resistance Code: Expressed in ohms. A three digit code where the first two digits are significant figures, and the third digit indicates the number of zeros that follow these figures (i.e., 100 = 10Ω; 101 = 100Ω; 102 = 1,000Ω; 103 = 10,000Ω; 105 = 1,000,000Ω ). See table for standard resistance values. For Single Unit: Specify taper and resistance code as shown. For Ganged Tandem Unit or Dual Unit: Specify a taper code and resistance code for each unit starting with the front unit followed by the rear unit. If both units have the same taper and resistance codes, add “X2” suffix per example below. Examples: B103A503 or if both units are the same: B103X2 For Triple Unit: Specify a taper code and resistance code for each unit starting with the front unit followed by the middle and rear units. If all units have the same taper and resistance codes, add “X3” suffix per example below. Examples: B103A503B104 or if all units are the same: B103X3 Resistance Taper: B = Linear. A = CW Audio (logarithm). C = CCW Audio (logarithm). Shaft End Style: S = Slotted; F = Flatted; R = Round. For Single Shaft: Specify the shaft length (FMS) and shaft end style as shown. For Dual Concentric Shaft: Specify the shaft length (FMS) and shaft end style for the inner shaft followed by the shaft length (FMS) and shaft end style for the outer shaft. Use a dash (-) to separate the code groups for the inner and outer shaft specifications. Example: 30R-20R Standard Shaft Length: 15 = 15 mm FMS. 20 = 20mm FMS. Up to 50mm shaft length available (special order ). Switch Type: ME = SPDT, 110VAC, 1A, Rear Exit Lug Terminals. MF = SPDT, 110VAC, 3A, Rear Exit Lug Terminals. SE = SPST, 110VAC, 1A, Rear Exit Lug Terminals. SF = SPST, 110VAC, 3A, Rear Exit Lug Terminals. Blank = No Switch. Style: N = Panel Mount, Single Unit, Single Shaft, Right Angle Ear-Lug Terminals. L = Panel Mount, Single Unit, Single Shaft with Shaft Lock, Right Angle Ear-Lug Terminals. G = Panel Mount, Ganged Tandem Unit, Single Shaft, Right Angle Ear-Lug Terminals on Each Unit. GL = Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft Lock, Right Angle Ear-Lug Terminals on Each Unit. T = Panel Mount, Triple Unit, Single Shaft, Right Angle Ear-Lug Terminals on Each Unit. D = Panel Mount, Dual Unit, Dual Concentric Shaft, Right Angle Ear-Lug Terminals on Each Unit. Operating Temperature Range: Y = 10C to 85C. Size: 30 = 30mm Diameter. TOCOS Series Name: RV = Carbon Film Element. Standard Resistance Values and Part Numbering Codes Standard Nominal Total Resistance Values and Part Numbering Codes Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code 100 200 500 501 201 501 1,000 2,000 5,000 102 202 502 10,000 20,000 50,000 103 203 503 100,000 200,000 500,000 104 204 504 1,000,000 2,000,000 5,000,000 105 205 505 Refer to Shaft End Styles Specifications and Hardware Specifications for details and availability. For additional information, refer to Guidelines and Precautions for Using Panel Controls. TOCOS AMERICA, INC. 48 1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com