MA-COM SW-395

SW-395
3 V GaAs SPDT Switch
DC - 2.0 GHz
Rev. V7
Functional Schematic 5
Features
•
•
•
•
•
Low Insertion Loss: <0.5 dB @ 900 MHz
Low Power Consumption: <10 µA @ 3 VDC
Very High Intercept Point: 52 dBm IP3
Both Positive and Negative 3 to 8 V Control
Low Cost SOT-26 Package
6
5
4
1
2
3
Description
M/A-COM’s SW-395 is a GaAs single pole, double
throw switch in a low cost SOT-26 surface mount
plastic package. The SW-395 is ideally suited for
applications where very low power consumption, low
intermodulation products, very small size and low
cost are required.
Typical application is an internal / external antenna
select switch for portable telephones and data
radios. In addition, because of its low loss, good
isolation and inherent speed, the SW-395 can be
used as a conventional T/R switch or as an antenna
diversity switch. The SW-395 can be used in power
applications up to 0.5 Watts in systems such as
cellular, PCS, GSM and other analog / digital
wireless communications systems.
The SW-395 is fabricated using a mature 0.5-micron
gate length GaAs PHEMT process. The process
features full chip passivation for increased
performance and reliability.
Ordering Information
5. DC blocking capacitors are not required if negative control
voltage is used.
Pin Configuration
Pin No.
Function
Pin No.
Function
1
RF1
4
Control B
2
Ground
5
RF Common
3
RF2
6
Control A
1
Absolute Maximum Ratings 6,7
Part Number
Package
SW-395
Bulk Packaging
Parameter
Absolute Maximum
SW-395TR-3000
3000 piece reel
Input Power
+33 dBm
Operating Voltage
+8.5 Volts
Storage Temperature
-65°C to +150°C
Operating Temperature
-40°C to +85°C
1. Reference Application Note M513 for reel size information.
Truth Table 2,3,4
Control A
Control B
RFC to RF1 RFC to RF2
0
1
Off
On
1
0
On
Off
6. Exceeding any one or combination of these limits may cause
permanent damage to this device.
7. M/A-COM does not recommend sustained operation near
these survivability limits.
2. For positive voltage control, external DC blocking capacitors
are required on all RF ports.
3. 0 = -8 V to 0 V, 1 = 0 V to +8 V.
4. Differential voltage, V (state 1) - V (state 0), must be +2.8 V
minimum and must not exceed +8 V.
1
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
• India Tel: +91.80.43537383
• China Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.
SW-395
3 V GaAs SPDT Switch
DC - 2.0 GHz
Rev. V7
Electrical Specifications: TA = +25°C, VC = 0 V / -3 V, Z0 = 50 Ω 8
Parameter
Test Conditions
Units
Min.
Typ.
Max.
Insertion Loss
DC - 1.0 GHz
1.0 - 2.0 GHz
dB
dB
—
—
0.5
0.6
0.7
0.8
Isolation
DC - 1.0 GHz
1.0 - 2.0 GHz
dB
dB
25
19
28
22
—
—
VSWR
DC - 2.0 GHz
Ratio
—
1.3:1
—
1 dB Compression
0.5 GHz, Input Power (3 V Control)
0.5 GHz, Input Power (5 V Control)
0.05 GHz, Input Power (3 V Control)
0.05 GHz, Input Power (5 V Control)
dBm
dBm
dBm
dBm
—
—
—
—
26
30
16
16
—
—
—
—
Trise, Tfall
10% to 90% RF, 90% to 10% RF
µS
—
5
—
Ton, Toff
50% Control to 90% RF, 50% Control to 10% RF
µS
—
3
—
Transients
In-Band
mV
—
15
—
Input IP2
2-Tone, 5 MHz spacing, 3 V Control, +10 dBm each
0.05 GHz
0.5 GHz
dBm
dBm
—
—
69
80
—
—
Input IP3
2-Tone, 5 MHz spacing, 3 V Control, +10 dBm each
0.05 GHz
0.5 GHz
dBm
dBm
—
—
48
52
—
—
Control Current
|VC| = 3 V
μA
—
1
10
8. For positive voltage control, external DC blocking capacitors are required on all RF ports.
SOT-26
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
• India Tel: +91.80.43537383
• China Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.
SW-395
3 V GaAs SPDT Switch
DC - 2.0 GHz
Rev. V7
Typical Performance Curves
Insertion Loss
Isolation
1.0
50
0.8
40
0.6
30
0.4
20
0.2
10
0.0
0.0
0.5
1.0
1.5
2.0
2.5
3.0
Frequency (GHz)
0
0.0
0.5
1.0
1.5
2.0
2.5
3.0
Frequency (GHz)
VSWR
1.6
1.5
1.4
1.3
1.2
1.1
1.0
0.0
0.5
1.0
1.5
2.0
2.5
3.0
Frequency (GHz)
3
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
• North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
• India Tel: +91.80.43537383
• China Tel: +86.21.2407.1588
and/or prototype measurements. Commitment to develop is not guaranteed.
Visit www.macomtech.com for additional data sheets and product information.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.