Document 369 -1 SMT Current Sensor – T6522-AL This low cost transformer is designed for use at 50 kHz to 300 kHz to sense continuous currents up to 3 Amps. The current windings can be connected in series to provide twice the output sensitivity. It offers 500 Vrms interwinding isolation. The small footprint, low profile, surface mount ceramic case makes it ideal for high-density boards and provides an excellent surface for pick and place operations. Applications include power supply feedback control, motor protection, overload sensing and detecting load drop or shutdown. To request free evaluation samples, contact Coilcraft or visit www.coilcraft.com. Turns (N)2 pri : sec 1 : 50 Inductance3 min (mH) 3.4 DCR max Ohms 1,2 – 5,6 3 – 4 0.006 0.70 1. When ordering, please specify packaging code: 2. 3. 4. 5. 6. 7. Frequency range (kHz) 50 – 300 Volt-time product4 (V-µsec) 30 RT for 1 Vout from 1 A Iin5 50 Ohms 3.0 2.5 Series Parallel 2.0 1.5 1.0 0.5 0 0 Typical Application Sensed current max Iin 3A Typical Response (with RT = 50 Ohm) T6522-ALD Packaging: D = 13″ machine ready reel. EIA-481 embossed plastic tape (750 per full reel). B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter D instead. The two primary windings may be connected in parallel (1 : 50) to provide up to 3 A (Iin) sensing capability (3 Vout), or connected in series (2 : 50) to provide twice the sensitivity (1 A Iin yields 2 Vout). Inductance is for the secondary, measured at 100 kHz, 0.1 Vrms. Maximum volt-time product for the secondary. Varying terminating resistance increases or decreases output Voltage/Ampere according to the following equation: RT = Vout × Nsec / Iin. Operating temperature range −40°C to +85°C. Electrical specifications at 25°C. Vout (Volts rms) Part number1 T6522-AL_ 0.5 1.0 1.5 2.0 2.5 3.0 Current (Amps rms) 3 1 2 I in 1T 50 T RT Vout 5 6 4 Specifications subject to change without notice. Please check our website for latest information. © Coilcraft, Inc. 2007 Document 369-1 Revised 03/20/07 Document 369-2 SMT Current Sensor – T6522-AL Dimensions 0.300 max 7,62 0.430 max 10,9 Notch indicates pin 1 0.25 max 6,35 Recommended Land Pattern 0.025 ref 0,64 0.055 typ 1,40 1 0.10 cen 2,54 6 3 0.065 1,65 4 0.290 7,37 0.290 7,37 6 4 0.040 1,02 3 1 0.100 cen 2,54 0.060 1,52 Weight: 0.9 g Termination: Tin-silver-copper over silver-palladium-platinum Tape and reel: 750/13″ reel 24 mm tape width For packaging data see Tape and Reel Specifications section. Specifications subject to change without notice. Please check our website for latest information. © Coilcraft, Inc. 2007 Document 369-2 Revised 03/20/07