THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS CW 0607 TFLD546EG5 40.00M SURFACE MOUNT 3.3V HCMOS TCXO ABSOLUTE M AXIMUM RATING S PARAMETER Storage Temperature Supply Voltage TFLD546EG5 TABLE 1.0 UNITS MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.6 - 6 Vdc MINIMUM 12.80 -4.6 0 NOMINAL - MAXIMUM 156.25 4.6 70 UNITS MHz ppm °C Vdc OPERATING SPECIFIC ATIONS NOTE DESCRIPTION TABLE 2.0 PARAMETER Frequency Range Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - 9 25 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - -60 -90 -120 -135 -145 1 - ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz INPUT CHARACTERISTICS NOTE The Connor-Winfield TFLD546EG5 is a Surface Mount Temperature Compensated Crystal Oscillator (TCXO). Operating at 3.3Vdc, the TFLD546EG5 will maintain ±4.6ppm frequency tolerance over 20 years. The TFLD546EG5 is offered in a surface mount package for automated assembly. 1 TABLE 3.0 Enable Voltage (High) (Vih) 70% Vcc - - Vdc Disable Voltage (Low) (Vil) - - 30% Vcc Vdc 2 FEATURES HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) (Voh) (Vol) Current (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% TABLE 4.0 MINIMUM 2.0 - (Ioh) (Ioh) -4 45 NOMINAL - MAXIMUM 15 0.4 UNITS pF Vdc Vdc - 4 55 5 mA mA % nS 50 3 NOTE 3.3V OPERATION OVERALL FREQUENCY TOLERANCE: ±4.6ppm OVER 20 YEARS. TEMPERATURE RANGE: 0 to 70°C LOW JITTER <1pS RMS TRI-STATE ENABLE/DISABLE FUNCTION PACKAG E CHARACTERISTICS Package TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. PROCESS RECOMMENDATIONS TABLE 6.0 Soldering Process Wash SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING RoHS 5/6 COMPLIANT See solder profile page 2. Ultrasonic cleaning is not recommended. Note: 1) Inclusive of calibration, frequenc y vs. temperature stability, suppl y voltage change, load change, shock and vibration, 20 years aging. 2) Oscillator output is enabled with no co nnection on pad 1. Output is at hig h impedance when disabled. ORDERING INFORMATION TFLD546EG5 - 40.00MHz TCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Tx147 PAGE 1 OF 2 REV: 02 DATE: 07/27/06 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Package Layout Suggested Pad Layout .210 MAX CW TFLD546EG5 40.00M (5.33mm) 3 4 2 5 1 6 .555 (14.10mm) KEEP OUT AREA .375 (9.52mm) Dimensional Tolerance: ±.005 (.127mm) Test Circuit Pin Connections Pin 1 2 3 4 5 6 3.3Vdc N/C 6 5 1 2 3 4 Connection Enable / Disable N/C Ground Output N/C Vcc E/D N/C Output Waveform Solder Profile Temperature 225°C 90% Ramp-Up Rate 3°C/second max. from 150°C to 225°C. 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C 100°C 10% 25°C 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: Tx147 PAGE 2 OF 2 REV: 02 DATE: 07/27/06 aCopyright 2001 Connor-Winfield all rights reserved.