THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C Storage Temperature Supply Voltage (Vcc) -0.5 - 7.0 Vdc Input Voltage (Vc) -0.5 - 7.0 Vdc MINIMUM 2 -20 0 3.0 NOMINAL 3.3 MAXIMUM 80 20 70 3.6 UNITS MHz ppm °C Vdc - -75 -100 -125 -135 -140 30 45 75 5 1 - mA mA mA pS rms pS rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz MINIMUM 2.0 - NOMINAL - MAXIMUM 0.5 UNITS Vdc Vdc OPERATING SPECIFICATIONS PARAMETER Center Frequency Total Frequency Tolerance Operating Temperature Range Supply Voltage (Vcc) 2 to 31.999 MHz 32 to 49.999 MHz 50 to 80.000 MHz Jitter (BW=10Hz to 20MHz) Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset (Icc) (Icc) (Icc) INPUT CHARACTERISTICS (Vih) (Vil) MINIMUM Vcc-0.5V - NOMINAL - MAXIMUM 15 0.4 UNITS pF Vdc Vdc -8 45 50 8 55 mA mA % Rise / Fall Time 10% to 90% - 3 5 nS Start Up Time - - 10 mS (Voh) (Vol) Current (High) (Low) Duty Cycle at 50% of Vcc (Ioh) (Ioh) PACKAGE CHARACTERISTICS Wash Notes 1.0 2.0 1 NOTE 2 2 TABLE 4.0 PARAMETER LOAD Voltage (High) (Low) Solder Reflow NOTE DESCRIPTION The Connor-Winfield FSLD54TE is a surface mount 3.3V fixed frequency Crystal Controlled Oscillator (XO) with an HCMOS output. The FSLD54TE is designed for applications requiring low jitter and tight frequency stability. FEATURES 3.3V OPERATION HCMOS OUTPUT CHARACTERISTICS PROCESS RECOMMENDATIONS FSLD54TE TABLE 3.0 PARAMETER Enable Voltage Disable Voltage Package NOTE TABLE 2.0 (Fo) Supply Current CW DATE CODE FSLD54TE 19.44M SURFACE MOUNT 3.3V HCMOS CLOCK OSCILLATOR NOTE OVERALL FREQUENCY TOLERANCE ±20ppm TEMPERATURE RANGE: 0°C to 70°C LOW JITTER <1pS RMS SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING TABLE 5.0 Non-hermetic package consisting of an FR4 subst rate with grounded metal cover. TABLE 6.0 The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. Inclusive of calibration frequency at 25°C, frequency vs. temperature stability, supply voltage change, load change, shock and vibration and aging for ten years. Oscillator output is enabled with no connection on pad 1 ORDERING INFORMATION FSLD54TE CLOCK SERIES - 19.44 MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: INT Hc185 PAGE 1 OF 2 REV: 00 DATE: 2/27/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .130 MAX CW DATE CODE FSLD54TE 19.44M (3.302mm) ENABLE / DISABLE GROUND OUTPUT Vcc Dimensional Tolerance: ±.005 (.127mm) ENABLE/ DISABLE Specifications subject to change without notice. DATA SHEET #: INT Hc185 PAGE 2 OF 2 REV: 00 DATE: 2/27/02 aCopyright 2001 Connor-Winfield all rights reserved.