DC/DC Converter TME Series 1 Watt Features Single-in-Line Package (SIP) I/O-Isolation 1‘000 VDC High Efficiency up to 80% Operating Temperature – 40°C to +85°C Pin-compatible with other Manufacturers 100% Burn-in (8 h) 2 Year Product Warranty The TME series is a range of sub-miniature , isolated DC/DC-converters in a SIP-package, which requires only 0.7 cm2 of board space. They provide a cost effective solution to generate supplementary, isolated voltages. Full SMD-design and a 100 % production test of parameters ensure a high reliability of this product. Models Ordercode TME 0505S TME 0509S TME 0512S TME 0515S TME 1205S TME 1509S TME 1212S TME 1215S TME 2405S TME 2409S TME 2412S TME 2415S www.tracopower.com Input voltage Output voltage Output current max. Efficiency typ. 5 VDC ±10% 5 VDC 9 VDC 12 VDC 15 VDC 200 mA 110 mA 80 mA 65 mA 70 76 77 78 % % % % 12 VDC ±10% 5 VDC 9 VDC 12 VDC 15 VDC 200 mA 110 mA 80 mA 65 mA 71 77 79 80 % % % % 24 VDC ±10% 5 VDC 9 VDC 12 VDC 15 VDC 200 mA 110 mA 80 mA 65 mA 70 76 79 79 % % % % Page 1 DC/DC Converter TME Series 1 Watt Input Specifications Input current no load /full load 5 Vin models 12 Vin models 24 Vin models 30 mA / 290 mA typ. 15 mA / 120 mA typ. 10 mA / 60 mA typ. Surge voltage (1 sec. max.) 5 Vin models 12 Vin models 24 Vin models 9 V max. 18 V max. 30 V max. Reverse voltage protection 0.3 A max. Reflected input ripple current can be reduced by ext. 1–3.3 µF polyester film capacitor Input filter Internal capacitors Output Specifications Voltage set accuracy ±3% Regulation ± 1.2 % / 1 % change Vin ± 10 % max. – Input variation – Load variation 20 – 100 % Ripple and noise (20 MHz Bandwidth) 150 mV pk-pk max. Temperature coefficient ± 0.02 % / °C Short circuit protection limited 1 sec. max. Capacitive load 33 µF max. General Specifications Temperature ranges – Operating – Case temperature – Storage – 40 °C ... +85 °C + 95 °C max. – 40 °C ... +105 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217 E) >2’000’000 h @ 25 °C Isolation voltage Input/Output 1‘000 VDC Isolation capacity Input/Output 60 pF typ. Isolation resistance Input/Output >1‘000 Mohm Switching frequency 90 kHz typ. (Frequency modulation) Frequency change over line and load ± 30 % max. All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. www.tracopower.com Page 2 DC/DC Converter TME Series 1 Watt Physical Specifications Case material non conductive black plastic (flammability to UL 94-V0) Package weight 1.3 g (0.05 oz) 1.7 g (0.06 oz) 5 Vin & 12 Vin models 24 Vin models Soldering temperature max. 260°C / 10 sec Outline Dimensions mm (inches) 10.2 (0.4) 3.2(0.13) 0.5 (0.02) Pin-Out 0.5 (0.02) 1.9 ±0.5 2.54 2.54 2.54 (0.08 ±0.02) (0.1) (0.1) Pin Single 1 –Vin (GND) 2 +Vin (Vcc) 3 –Vout 4 +Vout 0.5 (0.02) (0.1) (0.07) 7.0 (0.28) 24 V Models Bottom view 4 6.0 (0.24) 3 5.2 (0.2) 2 4.2 (0.17) 1.8 1 0.25 (0.01) 11.5 (0.45) 0.5 (0.02) Tolerances ±0.25 (0.01) pins ±0.05 (0.002) Specifications can be changed without notice Rev. 05/00 Jenatschstrasse 1 • CH-8002 Zurich • Switzerland Tel. +41-1284 2911 • Fax +41-1201 1168 • e-mail: [email protected] • internet: http://www.tracopower.com Page 3