! FEATURES • • • • • • Industry Standard 12.7x12.7mm SMT Footprint +5Vdc Supply Voltage -40°C to +85°C Temp. Range Low Phase Noise Tape & Reel Packaging Fully compliant to RoHS Directive 2002/95/EC VCO3030A 1700 M • M CTS 07XX DESCRIPTION The CTS VCO3030A is a high performance SMT VCO. Its low phase noise makes it the ideal choice for any wireless telecommunications system. • SeeWWW.CTSCORP.COM for product patent status. ELECTRICAL SPECIFICATIONS Parameter Conditions & Remarks Operating Frequency F OUT Supply Voltage VCC Supply Current I cc Operating Temperature Range TOP Storage Temperature Range TSTG Tuning Voltage Range VT Min 1700 4.75 -40 -40 0.5 -3 -5 -5 - Tuning Sensitivity Power Output (RF Amplitude) Pushing (5.0V +/-.3V) Pulling (VSWR = 1.67:1) Harmonics Spurious response 1kHz 10kHz Phase Noise 100KHz 1MHz ! " #$ % ,,, ! ! " & Typical 5.0 0 -94 -139 Max 1760 5.25 21 +85 +85 4.5 45 5 5 -8 -80 -67 -92 -117 -137 ' #$ () * + Unit MHz Vdc mA °C °C Vdc MHz/V dBm MHz/V MHz dBc dBc dBc/Hz dBc/Hz dBc/Hz dBc/Hz ! Pin 3 0.00 [.000] 2.92 [.115] 10.54 [.415] 4.0 MAX [.158] 5.46 [.215] 12.7±0.1 [.500±.004] 8.00 [.315] MECHANICAL SPECIFICATIONS: Pin 3 0.00 [.000] 2.03 [.080] VCO3030A 1700 M CTS 07XX Pin 1 12.7±0.1 [.500±.004] 2.92 [.115] 4.57 [.180] 5.46 Pin 1 [.215] 7.11 [.280] Pin 2 Pin 2 8.00 [.315] 9.78 [.385] 10.54 [.415] Ø.51 [.020] 16 places Recommended Land Pattern Pad Detail 3 Places 14.48 [.570] 1.78 TYP [.070] 2.67 [.105] 5.21 [.205] 10.29 [.405] Pin #1 mark 7.75 [.305] 12.70 [.500] 10.92 [.430] Function table Pin 1 2 3 4 1.78 [.070] TYP 1.52 [.060] TYP 10.92 [.430] 1.78 [.070] 0.79 [.031] Function Vt RF Output Vcc GND 1.32 [.052] 2.90 [.114] Note: The Lid/Sheild is grounded. 14.48 [.570] Pin 4 Exposed conductive ground plane 0.94 [.037] THIRD ANGLE PROJECTION 1.14 TYP [.045] Package outline 13 Ground Vias located approximately as shown All dimensions are in MM [Inches]. All dimensions are nominal unless otherwise specified. Lead Termination Finish: Gold Flash, <10 micro inch, over Ni plated Cu. - ! " #$ % ,,, ! ! " & ' #$ () * + ! Tape & Reel Information: Tape width 24 mm, pitch 16 mm, as per EIA 481-2, 1000 units max per 330 mm reel. 4.00 [.157] 1.75 [.069] 24.00 [.945] 16.00 [.630] Ø1.5 [.059] • All dimensions are in MM [INCHES]. All dimensions are Nominal STANDARD ENVIRONMENTAL LIMITS: This product is capable of operating within the following environmental conditions: Operating Temperature:-40 to +85 °C. Storage Temperature: -40 to +85 °C. Humidity: 85% Relative humidity max @ 50°C. Solder Reflow Conditions: Device is capable of withstanding reflow of 260 degrees C for 10 seconds maximum. Atmospheric Pressure: 730 to 780 mm Hg. Moisture Sensitivity: MSL 1 RoHS: This device is fully compliant to RoHS Directive 2002/95/EC ! " #$ % ,,, ! ! " & ' #$ () * +