SPECIFICATION CONTROL DRAWING 55A0833 TITLE THREE CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, GENERAL PURPOSE, 600 VOLT Date Revision 10-26-09 D This specification sheet forms a part of the latest issue of Raychem Specification 55A. COMPONENT WIRES - 55A0813 CABLE CONSTRUCTION DETAILS OUTSIDE DIAMETER (inches) PART NUMBER 1/ CONDUCTOR SIZE (AWG) NOMINAL MAXIMUM MAXIMUM WEIGHT (lbs/1000 ft.) 55A0833-26-* 26 .086 .091 5.2 55A0833-24-* 24 .097 .102 7.0 55A0833-22-* 22 .108 .112 9.8 55A0833-20-* 20 .125 .130 14.4 55A0833-18-* 18 .151 .158 22.0 55A0833-16-* 16 .166 .173 27.5 55A0833-14-* 14 .203 .210 42.2 55A0833-12-* 12 .240 .246 62.7 55A0833-10-* 10 .289 .298 55A0833-8-* 8 .421 .438 99.1 196. 55A0833-6-* 6 .521 .542 296. 55A0833-4-* 4 .670 .691 499. 55A0833-2-* 2 55A0833-1-* 1 .881 1.02 .907 1.04 783. 995. CABLE RATINGS AND ADDITIONAL REQUIREMENTS TEMPERATURE RATING: 200°C Maximum continuous conductor temperature VOLTAGE RATING: 600 volts (rms) at sea level INSULATION FLAWS: Spark Test, 5.7 kV (rms) at 3 kHz Impulse Dielectric Test, 8.0 kV (peak) PART NUMBER: The “*” in the part numbers above shall be replaced by color code designators with a slash separating the component wire colors. Colors shown do not necessarily reflect the sequence of manufacturing. 1/ Example: AWG 22, black, brown and red component wires: 55A0833-22-0/1/2 NOTE: Nominal values are for information only. Nominal values are not requirements. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. The TE logo, Tyco Electronics and Raychem are trademarks. Page 1 of 1 DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. Raychem Wire & Cable 501 Oakside Avenue Redwood City, CA 94063-3800 Phone: 1-800-227-8816 Fax: 1-650-361-6297 © 2009 Tyco Electronics Corporation. All rights reserved.