Oscilent Corporation IF SAW Filter | 835-IF70.0M-K Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF70.0M-K 35.0 x 12.8 Thru Hole Base Station & Repeater May 24 2003 . TYPE : 70.0 MHz Bandpass Filter 9.45 MHz Bandwidth PART NUMBER : 835-IF70.0M-K .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.95 70.00 70.05 MHz Insertion Loss - 28.5 30.0 dB 1dB Bandwidth 9.25 9.32 - MHz 3dB Bandwidth 9.45 9.52 - MHz 40dB Bandwidth - 10.28 10.35 MHz 50dB Bandwidth - 10.35 10.40 MHz Passband Ripple - 0.65 1.0 dB Group Delay Variation - 70 150 nsec Center Frequency - 4.40 - µsec Ultimate Rejection 50 55 - dB Substrate Material - LN - - Ambient Temperature - 25 - °C Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE No Matching Required Source/Load Impedance = 50 ohms Part No.: http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if70_0k.htm 835-IF70.0M-K 12/28/2005 Oscilent Corporation IF SAW Filter | 835-IF70.0M-K Page 2 of 2 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if70_0k.htm 12/28/2005