Oscilent Corporation IF SAW Filter | 835-IF100.0M-F Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF100.0M-F 35.0 x 12.8 Thru Hole Base Station & Repeater May 30 2003 . TYPE : 100.0 MHz Bandpass Filter 19.00 MHz Bandwidth PART NUMBER : 835-IF100.0M-F .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 99.91 100.00 100.09 MHz Insertion Loss - 24.5 27.0 dB 1dB Bandwidth 18.70 18.75 - MHz 3dB Bandwidth 19.0 19.05 - MHz 40dB Bandwidth - 20.15 20.20 MHz Passband Ripple - 0.90 1.2 dB Group Delay Variation - 50 100 nsec Absolute Delay - 2.70 - µsec dB Center Frequency Ultimate Rejection 50 55 - Substrate Material - 128° LN - - Ambient Temperature - 25 - °C * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 47nH C1 = 62pF L2 = 47nH C2 = 8pF Source/Load Impedance = 50 ohms Part No.: http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if100_0f.htm 835-IF100.0M-F 12/28/2005 Oscilent Corporation IF SAW Filter | 835-IF100.0M-F Page 2 of 2 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if100_0f.htm 12/28/2005