THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM PRODUCT DATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 3.3V HCMOS STRATUM 3 OCXO CW 0440 AGOF3S3 12.800M ABSOLUTE MAXIMUM RATINGS PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 °C (Vcc) -0.5 - 4.5 Vdc NOMINAL MAXIMUM UNITS (Fo) MINIMUM 1.544 - MHz -1.5 -0.25 -30 -2.5 -4.6 0 20.0 1.5 - 0.25 30 2.5 4.6 70 ppm ppm ppb ppm ppm °C Vdc Storage Temperature Supply Voltage OPERATING SPECIFICATIONS Frequency Calibration Frequency Stability Aging (Daily) Aging (20 Years) Total Frequency Tolerance Operating Temperature Range Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 450 mA Phase Jitter (BW=12KHz to 20MHz) - - 1 ps rms Phase Jitter (BW=10Hz to 20 MHz) - - 3 ps rms Period Jitter SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - -90 -135 - 5 5 1 2 ps rms dBc/Hz dBc/Hz Minutes nS nS MINIMUM 2.6 - NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc 50 - 4 55 6 mA mA % nS HCMOS OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% DESCRIPTION (Ioh) (Ioh) -4 45 - 1 2 3 4 5 FEATURES 3.3V OPERATION NOTE LOW JITTER <1pS RMS FREQUENCY STABILITY: ±0.25ppm TEMPERATURE RANGE: 0 to 70°C FREQUENCY TOLERANCE OF ±4.6ppm OVER TWENTY YEARS TABLE 4.0 PACKAGE CHARACTERISTICS Package The Connor-Winfield AGOF3S3 is a hermetically sealed 14 Pin DIP, 3.3V Oven Controlled Crystal Oscillator (OCXO) with an HCMOS/TTL compatible output. The AGOF3S3 is designed for higher stability Stratum 3 applications requiring low jitter and tight frequency stability. NOTE TABLE 3.0 (Voh) (Vol) Current NOTE TABLE 2.0 PARAMETER Center Frequency AGOF3S3 TABLE 1.0 14 pin DIP, hermetically sealed, grounded case, welded package Notes: 1) 2) 3) 4) Initial calibration @ 25°C Frequency vs. temperature stability, 0 to 70°C absolute. At the time of shipment after48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 20 years aging. 5) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation at a stable 25 °C. ORDERING INFORMATION AGOF3S3 OCXO SERIES - 12.800MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx011 PAGE 1 OF 2 REV: 06 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1m inute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 2003. 8 hour steam age prior to 245°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Topside board -mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15mi nute cycles 12 times each perpendicular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, half sine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. +3.3Vdc Specifications subject to change without notice. DATA SHEET #: Cx011 PAGE 2 OF 2 REV: 06 DATE: 11/12/04 aCopyright 2001 Connor-Winfield all rights reserved.