AM-146/AMC-146 High Performance Amplifier, 21 dB Gain, 10 - 500 MHz Features Rev. V3 FP-9 • 4 dB Typical Midband Noise Figure • +38 dBm Typical Midband Third Order Intercept • +24 dBm Typical Midband 1 dB Compression Description M/A-COM’s AM-146 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges. Due to the metal flatpack the thermal rise minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-146 is ideally suited for use where a high intercept, high reliability amplifier is required. C-25 Absolute Maximum Ratings 1 Parameter Absolute Maximum Max. Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C 1. Operation of this device above any one of these parameters may cause permanent damage. Pin Configuration Pin No. Function Pin No. Function 1 RF OUT 6 RF IN 2 GND 7 GND 3 GND 8 GND 4 GND 9 GND 5 VDC 10 VDC 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-146/AMC-146 High Performance Amplifier, 21 dB Gain, 10 - 500 MHz Rev. V3 Electrical Specifications: 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions o Frequency Units Min. Typ. Max. Gain @+25 C 50 MHz dB 20.3 21.0 21.7 Frequency Response — 10 - 500 MHz dB — — ±1.0 Gain Variation with Temperature — 10 - 500 MHz dB — — +-0.8, -1.2 1 dB Compression Output Power 10 - 500 MHz dBm +20.0 — — Noise Figure — 10 - 500 MHz 10 - 300 MHz dB dB — — — — 7.0 5.5 Reverse Transmission — 10 - 500 MHz dB — -35 -30.0 VSWR — 10 - 500 MHz Ratio — — 2:1 Output IP2 Two-Tone inputs up to +10 dBm 10 - 500 MHz dBm +40 — — Output IP3 Two-Tone inputs up to +10 dBm 10 - 500 MHz dBm +30 — — Vbias — — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC — mA — 130 140 Power Dissipation @ +15 V Bias — mW — 2 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 2 W must be provided in use. S-Parameter Data Frequency (MHz) S11 MAG/ANG S21 MAG/ANG S12 MAG/ANG S22 MAG/ANG 10 0.13/-118.5 11.44/16.8 0.02/7.1 0.14/164.6 20 0.12/-144.0 11.63/-1.0 0.02/-4.0 0.16/168.2 50 0.13/-175.5 11.56/-27.1 0.02/-25.3 0.15/155.9 75 0.14/169.0 11.49/-44.3 0.02/-41.3 0.13/143.8 100 0.15/163.8 11.45/-59.9 0.02/-55.7 0.08/132.5 200 0.16/121.4 11.24/-120.3 0.02/-113.3 0.05/160.6 300 0.18/86.3 11.34/176.4 0.02/-170.1 0.07/167.7 400 0.20/55.2 11.33/110.4 0.02/133.3 0.12/159.2 500 0.23/13.1 10.84/31.1 0.01/75.6 0.23/174.8 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-146/AMC-146 High Performance Amplifier, 21 dB Gain, 10 - 500 MHz Rev. V3 Typical Performance Curves Ordering Information Part Number Package AM-146 PIN Flatpack AMC-146 SMA Connectorized 3 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.