AM-151/AMC-151 Cascadable Amplifier 10 to 500MHz Rev. V5 Features Product Image • NOISE FIGURE: 5 dB (TYP.) • HIGH THIRD ORDER IP: +38 dBM (TYP.) • P1dB: +21 dBm (TYP.) Description The AM-151 amplifier uses a coupler feedback design with high intercept and compression points. The use of coupler feedback minimized noise figure and DC current in a high intercept amplifier. This amplifier is packaged a TO-8 package. Due to the internal power dissipation, the thermal rise is minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-151 is ideally suited for use where a high intercept high reliability amplifier is required. Absolute Maximum Ratings Ordering Information Part Number Package AM-151-PIN* TO-8-1 AMC-151- SMA** SMA Connectorized *Mounting kit part number AU00071 required for PCB application **SMA Connectorized part is not RoHs compliant. Parameter Absolute Maximum Maximum Input Power +20 dBm DC Voltage +15.75 V Continuous Input Power +18 dBm Operating Temperature -55º to +85ºC Storage Temperature -65º to +125ºC Electrical Specifications: Z0 = 50Ω, VCC = +15 VDC** Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25oC 50 MHz MHz 11.5 12.0 12.5 Frequency Response 5-500 MHz dB ±1.0 Gain Variation with Temperature 5-500 MHz dB ±0.8 5-500 MHz 10-500 MHz dBm dBm Noise Figure (max) 5-500 MHz dB Reverse Transmission 5-500 MHz dB VSWR 5-500 MHz Ratio 1 dB Compression Output Power +19 +20 7.0 -16.0 2.0:1 Output IP 2 Two-tone inputs up to +10 dBm 5-500 MHz dBm +48 Output IP 3 Two-tone inputs up to +10 dBm 5-500 MHz dBm +34 dBm +14.5 V bias -13.0 +15.0 +15.5 100 I bias V bias = +15 Vdc mA 85 Power Dissiapation @ +15 V Bias mW 1275 ***Heat Sinking: Operation at case temperature above +95oC is not recommended. Heat sinking adequate to dissipate 1.3 W must be provided in use. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. AM-151/AMC-151 Cascadable Amplifier 10 to 500MHz Typical Performance Curves at +25°C Rev. V5 Outline Drawing: TO-8-1 * Gain DC IN RF IN .150 TYP. (3.8) RF OUT .300 (7.6) TYP. GND 4X Ø .018+/-.005 (0.46+/-0.13) .220 MIN (5.6) .220 (5.6) MAX .450 (11.4) Ø .50 (12.7+0.5) WEIGHT (APPROX) 0.10 OUNCES 2.8 GRAMS Outline Drawing: SMA Connectorized * 1.344 (34.14) .562 (14.28) DC IN .457 (11.61) 0.72 (17.07) 1.344 (34.14) .375+/-.020 (9.53+/-0.51) 2X CONNECTOR .750+/-.020 (19.05)+/-0.5 .672 (17.1) 2X .12 112-40 UNC-2B .46 20 Ø 1.000 (25.4) WEIGHT (APPROX) 1.62 OUNCES ∗ 46 GRAMS Dimensions in ( ) are in mm. Unless otherwise noted: .XXX = + .010” (.XX = + 0.25) .XX = + 0.02 (.X = + 0.5) 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.