DAQ6103 - Teledyne Cougar

Rev. 7/10
0.1 TO 6.0 GHz
ANALOG DETECTOR
DAQ6103
DAQ6103
Typical Values @ +25 °C
Wide Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . .
Wide Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . .
Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Single or Dual Power Supply
Cougar Q Package
0.1 to 8.0 GHz
–10.0 to +25.0 dBm
± 0.25 dB
± 0.5 dB
1.2:1
DAQ6103
SM-25 for Detectors
SPECIFICATIONS*
Parameter
Typical
Frequency (Min.)
Input Power Range (Min.)
VSWR (Max.)
Guaranteed
0 to 50 °C
-55 to +85 °C
0.1-8.0 GHz
0.1-6.0 GHz
0.1-6.0 GHz
-10 to +25 dBm
-5 to +20 dBm
-5 to 2+0 dBm
1.2:1†
1.5:1†
1.5:1†
120 mV†
90 mV†
90 mV†
Power Flatness (Max.)
±0.5 dB^
±0.75 dB^
±0.75 dB^
Temperature Stability (Max.)
±0.25 dB†
±0.5 dB†
±0.5 dB†
Output Offset Voltage,
no RF (Max.)
±0.5 mV
±2.0 mV
±2.0 mV
1 dB Square Law Departure
+10 dBm
—
—
Tangential Sensitivity
-25 dBm^^
—
—
Pulse Response, Pin = +5 dBm
1.5 µsec‡
—
—
Pulse Response, Pin = +25 dBm
3.0 µsec‡
—
—
Max Output Voltage
Vs-1 Volts
—
—
Supply Current, no RF
2 +mA, 2 -mA
—
—
Supply Current, Pin = +25 dBm
10 +mA, 2 -mA
Sensitivity, Vout (Min.)
DAS6103
* Measured in a 50-Ohm system at ±5 Vdc, 2 KΩ||50 pF unless otherwise specified.
† Pin = +5 dBm. ^ Vout = 100 mV. ^^ 3 dB NF, 1 MHz Bandwidth. ‡ 50% RF to 10 or 90% Video.
SMTO-8 Package for Detectors
MAXIMUM RATINGS
DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . .
Operating Case Temperature . . . . . . . . . . . . . . . . . . . .
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . .
Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . .
Detector Thermal Resistance1 (θjc) . . . . . . . . . . . . . . .
Temperature Rise @ +20 dBm (Tjc) . . . . . . . . . . . . . . .
1 Thermal
±18 V
+27 dBm (±5 Vdc)
-55 °C to +100 °C
-65 °C to +125 °C
+100 °C
+3500 °C/Watt
+3.5 °C
resistance is based on RF input power. Ratings based on +25 °C.
ABSOLUTE MAXIMUM RATINGS
This unit is DC coupled and employs a RF choke at the input (DC short). If the application
calls for the input to sink current there will approximately be an additional 1 mV of output
offset voltage for each 3 mA of current. Sink current should be limited to 100 mA max to
avoid choke burnout.
For higher supply voltages, up to ±15 volts, the positive supply pin must include a series
current limiting resistor, Rs = (Vs – 5)/0.01. (e.g.: Vs = 15v, Rs = 1K)
Average power detection is obtained at power levels below approximately +7 dBm.
For best pulse response the supply pins should be bypassed with an additional
0.1 µF capacitor. The unit contains 0.01 µF internal capacitors.
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • microwave@teledyne.com
DAQ6103
TYPICAL PERFORMANCE
INPUT POWER - dBm
Input Flatness @ Vo = 100 mV
KEY: +25 C
+85 C
-55 C
6.0
5.0
4.0
3.0
2.0
0.1
0.7
1.3
1.9
2.5
3.1
3.7
FREQUENCY - GHz
4.3
4.9
5.5
6.1
Input VSWR @ Pin = +5 dBm
1.50
VSWR
1.25
Pulse Response @ Pin = 0 dBm
1.00
0.75
0.50
0.1
0.7
1.3
1.9
2.5
3.1
3.7
FREQUENCY - GHz
4.3
4.9
5.5
6.1
Transfer Curve Vcc = +10 V
10.0
OUTPUT VOLTAGE - VOLTS
1.0
0.1
0.01
Pulse Response @ Pin = –15 dBm
0.001
0.0001
-30
-20
-10
0
10
INPUT POWER - dBm
20
30
40
650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • microwave@teledyne.com