English Datasheet

DCP42 160W Single Continuous
Switching Power Supply with USB
Continuous switching Power Supply offers high
efficiency electrical power conversion for greater
energy conservation and lighter weight.
- Laboratory use
- Bench Testing, Service, and Repair
- Research and Development facilities
- Educational and Institutional Training
Constantly calculates and adjusts the Voltage
Three on-board user-defined Voltage/Current presets
and Current limit points according to available
Store 20 presets with up to 999 cycles each on a PC
via USB and supplied Software
maximum power (160W)
At maximum current (10A), voltage is limited to 16V;
Waveform Generator
at maximum voltage (42V), current is limited to 3.8A
Dual action rotary encoder control with push
Software also includes DC Ramp and
Complete with power cord, software, and USB cable
knob for fine and coarse tuning
Remote control for Programming, Output Voltage/
Current, and ON/OFF using supplied software, driver,
and USB
Output Voltage
0 to 42V
Output Current
0 to 10A
Basic Accuracy
±(0.2%+5 counts)
Load Voltage Regulation
≤0.15% (10-100% rated current)
Line Voltage Regulation
≤0.02% (90-264V AC)
Load Current Regulation
≤0.5% (10-90% rated voltage)
Line Current regulation
≤0.1% (90-264V AC)
Ripple and Noise
≤5m Vrms, ≤50m Vp-p
Dimensions/ Weight
7.9 x 3.7 x 9.5” (200 x 95 x 245mm)/ 5lbs (2.3kg)
DCP42............... 160W Single Continuous Switching Power Supply with USB (100-240V)
Specifications subject to change without notice. Copyright © 2013 FLIR Systems, Inc. All rights reserved including the right of reproduction in whole or in part in any form.
Rev. 4/18/13
Similar pages