DC-AC INVERTER UNIT PS-DA0211-05(S) (11 W DUAL OUTPUTS) DESCRIPTION : This low profile DC to AC Inverter is developed for dual lamps. APPLICABLE LCD: 6.4 to 15 inches double lamp type Lamp Voltage 650 Vrms Lamp Current 2 x 5.5 mArms Lamp Start Up Voltage 1.500 Vrms (Vin : 12 Vdc) FEATURES : Remote ON/OFF Open Lamp Detection RoHS compliant (S) TEMPERATURE & HUMIDITY : Operating Temperature Range Storage Temperature Range Humidity 140 x 24 x 14 mm Q2 C3 C6 R21 C8 R15 R18 C12 R4 T1 CN3 CAUTION Q11 R8 L2 ? ? R2 C4 C5 C10 R9 Q12 R20 R3 ? ? R7 ! R5 ? CAUTION CN2 1 CN1 F1 D4 D3 DA0211- D1 CN1 D2 1 Q1 REV:1.0 A0 ! T2 R6 CN3 3.2Ø X2 PIN 1 PIN 1 C2 ? LxWxH R1 DIMENSIONS : -10°C ~ +60°C -40°C ~ +85°C 95 %RH max 1 C1 CN2 L1 Unit : mm Weight :39,8 (g) typ. PIN 1 Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 Part Description PCB Connector CN1 Qty. 1 1 Material UL94V-0 (FR-4 or CEM-3) S5B-PH-SM3 Note t=1m m JST or equal 3 Connector CN2 + CN3 2 SM02(8.0)B-BHS-1-TB JST or equal Input side CN1: Output side CN2: Pin No. CN 1-1 CN 1-2 CN 1-3 CN 1-4 Symbols Vin GND Vbr GND Ratings 10.8 ~ 13.2 Vdc CN 1-5 Vrm t 0 ~ 0.4 = OFF / 4.5 ~ Vin = ON Pin No. CN 2-1 Symbols Vhigh Ratings 650 Vrms (5.5 mArms) CN 2-2 Vlow (GND) 0 ~ 4.2 Vdc Output side CN3: Pin No. CN 3-1 Symbols Vhigh Ratings 650 Vrms (5.5 mArms) CN 3-2 Vlow (GND) Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.2.1, 10th March 2011 DC-AC INVERTER UNIT PS-DA0211-05(S) (11 W DUAL OUTPUTS) ELECTRICAL CHARACTERISTICS : Parameters Symbols Output Current Output Current Input Current Frequency Open Circuit Voltage No load Shutdown Iout Iout Iin F Vopen Tsd Note 1 : Note 2: Conditions Vrmt Vin (V) Tu (°C) (V) 12±1.2 5±0.25 0 ~ +50 12±0.6 5±0.25 0 ~ +50 12±1.2 5±0.25 0 ~ +50 12±1.2 5±0.25 0 ~ +50 11.4 5±0.25 0 ~ +50 12±1.2 5±0.25 0 ~ +50 Specification Min. Typ. Max. 5.0 2.0 44.5 1.300 1.0 5.5 2.5 0.84 52 1.500 - 6.0 3.0 1.23 59.5 1.700 - Unit Note mArms mArms Adc kHz Vrms sec Vbr = 0 Vdc Vbr = 4.2 Vdc wit hout load Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked on mechanical drawing and any conductors. Dimming function: Brightness max. @ Vbr = 0 Vdc, Brightness min. @ Vbr. = 4,2 Vdc. TEST CIRCUIT : SW 1 Operation of unit a Operation b Non operation Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.2.1, 10th March 2011